Industrial Water Softeners SF-110F Series

Pure Aqua’s water softeners treat the water by removing hardness using resin. The resin replaces the hardness in the water with salt which is regenerated periodically. The softened water can then pass through an RO system to remove the salt without the risk of scaling.Standard FeaturesThese softeners are designed as fully automatic units either with timer or meter control. The timer controller initiates auto-matic regeneration and features a 7 or 12 day calendar wheel. Time of regeneration and length of time for each regeneration cycle are fully adjustable. The metered models start regener-ation based on the total gallons used. The FRP mineral tank is engineered for a 150 psi working pressure and is tested to 160 psi. A premium grade sulfanated nonphenolic polystyrene type resin is contained in the mineral tank. The resin will deliver 30,000 grains per cubic foot when brined at a rate of 15 lbs. per cubic ft. The brine tank is a combination of high density polyethylene tank and a brine valve, including an air eliminator valve and a safety brine refill shut-off to prevent tank overflow. The under drain utilizes either a hub and lateral or a header and lateral system to evenly distribute water and prevent resin loss, and to insure minimal pressure drop at peak flow.Available Options®Pure Aqua, Inc.SERIESSSSSSDuplex, triplex or multi unitsSkid mounted, plumbed & wiredPLC control systemAlternate water meter typesBrine pump systemsSteel resin tanksASME coded tanksButterfly control valvesInline hardness monitorUnistrut channel supportsSSSSSIndustrial Water SoftenersFRP Tanks: 16” to 63” DiameterIndustrial Water SoftenersFRP Tanks: 16” to 63” Diameter SERIESSystem SpecificationsSSSSSSSSSSSSValve connections: MPT: 1.5”; male spig weld: 1.5”, 2”; female socket weld: 2”; flanged: 2”, 3”Recommended service flow rates/ranges are based on the cu.ft. of the tank/filter bedSlower flow rate per cu.ft. = better fltration2 GPM/cu.ft. = minimum “superior softening” (< 0.15 grain (3 ppm) of hardness leakage), < 2 psi drop3.5-5 GPM/cu.ft. = average grade softening (up to 1 grain (17 ppm) of hardness leakage), < 5 psi drop5-10 GPM/cu.ft. = utility softeningPeak flow rates are based on 10 GPM/cu.ft. or > 12 psi loss, whichever occurs firstBackwash rates allow 50% bed expansion at 60°F.Operating pressure: 150 psi (10 bar) for the tank and 100 psi for the overall systemMaximum temperature: 140°F (60°C)Capacity based on 23 grains (400 ppm) of hardness as CaCO3 at 2 to 4 GPM/cu.ft. (2 to 1 CaCO3 to Mg ratio)Hardness leakage of < 3 ppm (0.2 grains) @ 6 lb. NaCl, and < 1 ppm (0.1 grains) @ 12 lb. NaCl.ASSOCIATIONWaterQualityMEMBERBBBISO9001CERTIFIED9001:2008ISO© 2013 Pure Aqua, Inc. All Rights Reserved. Speciications subject to change without notice.Authorized Dealer:Tel: +1-714-432-9996Fax: +1-714-432-9898sales@pureaqua.comwww.pureaqua.comWater Treatment and Reverse Osmosis Systems®Pure Aqua, Inc.