Instilation Instruction Square Heritage - Brochure

Cleaning water and then washed with a mild detergentsolution using a bristle brush or sponge. Care shouldbe taken not to apply undue pressure that maydamage labels. Flush clean with water after washing.Manufacturing Standard (as applicable)All Lea?eld Environmental products aremanufactured to BS EN ISO 9002.Plastic materials: Mechanical properties tested toBS 2782 Hot dipped galvanized: BS 729Powder coating: BS 3900 Zinc coating: BS 1706Tools Chalk, hammer drill, 12mm masonry drill bit, mallet, 17mm socket, Key: PPE Always wear appropriate PPE equipment andfollow safety guidelines Installation guidelinesLEAFIELD litter binsSquare Heritage Position the bin so that the bin door faces the correct direction and is not obstructed Using chalk, mark the position through the four holes in the bin base onto the ground bellow Remove bin body and clearly mark the ground in the four hole positions with a cross 1 2 3Preparationadditional components:Available as optionalextra.WasherX3X3100mmDrill 12mm holes in the four marked positions to a depth of 100mm to accommodate the bolt length. Remove debris from holesRe-position the bin over the drilled holes. Add washers to bolts and push through moulded holes in base into drilled ground holesUsing a mallet drive the bolts homeUse a spanner or socket to tighten the bolts Tighten the bolts to 22.0Nm torque for concrete. Tightening the bolts will fan out the bolt sheath in the hole holding the bolt secureReplace liner and shut door 4 5 67 8 9Drilling holes and inserting bolts Tightening bolts telephone+ 44 (0)1225 816500enter fax numberfacsimile+ 44 (0)1225 816501postCorsham, Wiltshire SN13 9UDwebsite/emailwww.lea?eld-environmental.comenvinfo@lea?eld-environmental.com