Model 104S Dry Running, Self Priming, Solids Handling Diesel Engine Pump System Brochure

Properties:? Clog resistant impeller and liner in wear resistant configuration, 3R configuratiion.? Impeller has large free passage of 3”.? Very economical. Fuel consumption is 50% lower than conventional dirty water pumps with the same free passage.? Large pump capacity combined with a low engine power rating.? The pump set primes very quickly even at high suction lifts.? The vacuum system can handle large quantities of air. Up to 59 cfm, standard is 15 cfm.? Capable of pumping unscreened raw sewage water.? Capable of pumping viscous liquids.? The wear liner can be adjusted from outside the pump. R1 and R3 configuration.? Electronic vacuum system.? Pump can dry prime down to 28 feet.? Automatic start / stop system (level switching).? Very low noise emission.? Double shaft seal immersed in oil bath guarantees an extended shaft seal life (silicon / tungsten)Applications:? Sewer Bypass.?Well pointing and drainage lines.?Drainage of building sites.? Pumping bentonite and sludge.? Emergency pump station.Technical specifications:Discharge Flange - 6” 125 LBS. ANSI.Capacity (maximum) 2000 GPM.Head (maximum) 210 Feet.Engine type and make Deutz / BF4M2011, 4 cylinder oil cooled diesel engine.Engine power rating 63 HP @ 1800 RPM.Required pump power 52 HP @ 1750 RPM.Engine starting system 12 volt DC manual and automatic level switching.connectionSuction connection Flange - 8” 125 LBS. ANSI.Pump type and manufacture F04K-S01(3)R / Hidrostal Screw Centrifugal.Capacity diesel tank 125 gallon, sufficient for 48 hours continuous running at maximum load (1500 RPM).Acoustic canopy Noise emissions reduced to 65 dB(A) at 23 ft. Distance.Weight Approximately 6000 Lbs.SCREWSUCKER™SCREWSUCKER™PUMPING BY APSCOModel 104S, Dry Running, Self Priming, Solids Handling Diesel Engine Pump SystemThe canopy doors can be locked. The fuel tank is built into a container toprevent leakage. The fuel tank container has a built in oil separator.A hand pump is built in to assist in pumping out diesel engine sump anddouble bottom. The entire canopy is constructed from galvanized steel sheeting.70.5”fromGroundtoCenterlineofDischarge85.75”Dimensions are in inches.Dimensions are in inches.Dimensions, configuration and weight can beDimensions, configuration and weight can bechanged or vary without notice.Drawing is not to scale.Suction flange: 8” 125# ANSI.Discharge flange: 6” 125# ANSI.Drawing is not to scale.Suction flange: 8” 125# ANSI.Discharge flange: 6” 125# ANSI.Brochure 104S - 020507APSCO, INC. 1-800-791-6195P. O. Box 2639 - Kirkland, WA 98083-2639Ph: (425) 822-3335 / Fax: (425) 827-6171S SCREW UCKER™S SCREW UCKER™Model 104S126”132.5”137”74.25”43.25”85.75”Discharge flange6” 125 Lb. ANSISuction flange8” 125 Lb. ANSIAccess doordiesel engineAccess door pumpLifting eyeair cooling34.5”air coolingair cooling1500 rpm3”1800 rpmModel 104S2000 rpmQ (GPM)H(Feet)