Model 125H - Dry Running, Self Priming, Solids Handling Diesel Engine Pump System Brochure

Properties:? Clog resistant impeller and liner in wear resistant configuration.? Impeller has large free passage of 4”.? Fuel consumption is 50% lower than conventional dirty water pumps with the same free passage.? Large pump capacity combined with a low engine power rating.? The pump set primes very quickly even at large suction heights.? The vacuum system can handle large quantities of air. Up to 60 cfm, standard is 15 cfm.? Capable of pumping unscreened raw sewage water.? Capable of pumping viscous liquids.? The wear liner can be adjusted from outside the pump. R1 and R3 configuration.? Electronic vacuum system.? Pump is capable of long running times in snore conditions.? Pump can dry prime down to 28 feet.? Automatic start / stop system (level switching).? Very low noise emission.? Double shaft seal immersed in oil bath (sic/sic and carbon/ceramic)Applications:? Pumping out sewage pits and cellars.? Drainage of building sites.? Well pointing and drainage lines.? Pumping bentonite and sludge.? Emergency pump station.Technical specifications:Discharge and suction connections Flange - 6” 125 LB. ANSI.Capacity (maximum @ 1800 RPM) 1900 GPM.Head (maximum @ 1800 RPM) 136 Feet.Engine type and make Caterpillar C2.2 Water Cooled.Engine power rating 23 HP @ 1500 RPM. 29 HP @ 1800 RPM.Pump type and manufacture E 125-H Hidrostal Screw Centrifugal.Required pump power 14.7 HP @ 1500 RPM and 28 HP @ 1800 RPM.Engine starting system 12 volt DC manual and automatic level switching.Capacity diesel tank 66 gallons sufficient for 72 hours continuous running at maximum load.Acoustic canopyWeight Approximately 3880 lbs.Noise emissions reduced to 60 dB(A) at 23 feet distance.The canopy doors can be locked. The canopy serves as a containment vessel toprevent leakage from the unit. The vessel also has a built in oi/water separator.A hand pump is built in to assist in pumping out diesel engine sump and containmentfluids. The entire canopy is constructed from galvanized steel sheeting.S SCREW UCKER™S SCREW UCKER™PUMPING BY APSCOModel 125H, Dry Running, Self Priming, Solids Handling Diesel Engine Pump System37.3”90.2”80.3”65.6”72”4”12” 6”Standard ConfigurationAlternate configurationDimensions are in inches.Dimensions, configuration and weight can bechanged or vary without notice.Discharge & suction connections are 6” 125 LB ANSIDrawing is not to scale.Dimensions are in inches.Dimensions, configuration and weight can bechanged or vary without notice.Discharge & suction connections are 6” 125 LB ANSIDrawing is not to scale.PumpEngineEngineBrochure 125H - 020507APSCO, INC. 1-800-791-6195P. O. Box 2639 - Kirkland, WA 98083-2639Ph: (425) 822-3335 / Fax: (425) 827-6171Model 125PumpS SCREW UCKERS SCREW UCKERQ (USGPM)400 400 1200 1600 200080075%75%080120160H(Feet)1500 rpm1800 rpm4”Model 125H