Multi-Section Poly Flighting Assembly Instructions

© Lundell Plastics Corporation · 400 W Market St. · Odebolt, IA 51458 · P 712.668.2400 · TF 877.367.7659 · F 712.668.2402Visit us online at www.lundellplastics.com to see other innovative products3121:5 Page 1 of 11. Remove the bolt from the tube section to be joined to the All-Hex Connector. 2. With the flight edges lined up, slide the All-Hex Connector into the section. 3. Where the flighting edges meet, use a putty knife to spread them apart while sliding the two sections together. 4. Use a punch to help line up the holes in the sections and the All-Hex Connector. 5. Replace the bolt and lock nut, making sure not to over tighten against the Poly Flight hub.ASSEMBLY INSTRUCTIONSMulti-Section Poly FlightingMulti-Section Poly Flighting Assembly InstructionsPLEASE READ THE ENTIRE INSTRUCTION SHEET BEFORE STARTING INSTALLATION. Please refer to the manufacturer’s operator’s manual for pertinent safety precautions. THINK SAFETY. WEAR SAFETY GLASSES.WARNING Proper application, installation, and operation of any machine and/or installation incorporating products sold by Lundell Plastics Corporation™ is the responsibility of the purchaser and/or end user. All local, state, and federal safety codes must be followed. Lundell Plastics Corporation™ is specifically not responsible for property damage and/or personal injury, direct or indirect, for damages and/or failures caused by improper design, application, installation, operation, abuse, and/or misuse of its’ products. Conveyors must never be installed, readied for operation, or operated without proper covers and guards installed and securely in place.