Polycoat-Polycast - PPG 90A - Aliphatic Datasheet

Material Data SheetSystem Number 2718304BPolycoat-Polycast® PPG Aliphatic 90ATypical Physical Propertiesfor Cured Material Hardness Shore A 90 ± 2Ultimate Tensile PSI 2311Tensile Strength PSI @100% 1177PSI @300%Ultimate Elongation % 199Die C Tear PLI 420Split Tear PLI 61Resilience % Rebound 56Compression Set % 20Typical Physical Propertiesfor Components A BViscosity, cps 600 1050Mix Ratio, by Weight 56.25 100Processing Parameters A-side Temperature ºF 80B-side Temperature ºF 80Mold Temperature ºF 150-180Gel Time Seconds 40Demold Time Minutes 15Post Cure Time Hours 24Note: A-side (Polycoat-Polycast® ISO 2718304A) used in all the above tested.Note: The conditions of your use and application of our products, technical assistance and information (whether verbal, written or by way of production evaluation), including any suggested formulations and recommendations, are beyond our control. Therefore, it is imperative that you test our products, and request technical assistance and information to determine to your own satisfaction whether they are suitable for your intended uses and application. A Division of American Polymers 14722 Spring Avenue, Santa Fe Springs, CA 90670-5108 USA ? Tel: 562/802-8834 ? Fax: 562/921-7363 ? www.polycoatusa.com ? Copyright© May 2011 Polycoat Products