Snap Sampler Deployment Brochure (PDF 427 KB)

Snap Sampler Deployment (page 1 of 2)Inserting and securing bottlesGentlyseat set “Connector”Insert Version 01-10InsertbottleSlide on; twist to seat“FRONT” screwInsert bottleA) I t 40 l VOA i t t f 40 l S S l(A) (B) (C) (D)FRONT toward blue release pins40ml 125ml or350mlA) Insert 40 ml VOA into top of 40 ml Snap Sampler…B) Insert 125ml or 350ml POLY into back side of 125 ml Snap Sampler.C) Slide twist-on “Connector” over sampler and twist clockwise to seat—the word ”FRONT” should appear above the blue release pins.D) Gently secure connector with blue set screw.E) Set All Bottom Snap Caps First, then Top Snap Caps. Insert Snap Driver blade into the upper hole of the concave side of Snap Cap; align driver over pp p p; gthe release pin that you will set the Snap Cap.F) Push down on Snap driver handle to lift Snap Cap; grasp driver or use thumb to push driver down; keep fingers clear of the under-side of the driver tool.G) Pivot on the notch in the driver handle until driver handle is flush/parallel with sampler body and Snap Cap is in its seat.H) Push release pin up through lower hole in the Snap Cap; repeat “E” H) Push release pin up through lower hole in the Snap Cap; repeat E through “H” for each Snap Cap and all Samplers.Setting Snap Caps(E) (F) (G) (H)End rotation Push release Concave side of Do not lift cap– End rotation with driver parallel to sampler bodypin up through hole in Snap Capcapo ot t capPush driver handle Downto setDriver Place driver blade through concave side of upper Snap Cap hole; align driver handle at release pinPivot notchPush driver handle Downto lift Snap CapDriver handle Parallel to Sampler BodySnap Sampler Deployment (page 2 of 2)Attaching manual triggerFeed ball Trim Insert trigger Version 01-10ball fittingPress in ball fittingAdd safety cable tieTrim excess Snap Captrigger tubing clipClick barb in placeA) Insert trigger in right/upper release pin groove feed ball fitting first(A) (B) (C) (D) (E)A) Insert trigger in right/upper release pin groove—feed ball fitting first.B) With trigger barb facing out, insert trigger until barb clicks into position.C) Press ball fitting into release pin using Snap Driver Tool.D) Attach safety cable tie.E) Trim protruding Snap Caps between ribs (required for smaller diameter ) p g p p ( qwells). Where more than one sampler is attached to one trigger, connect ball-end connector cables between each sampler (not shown).F) Lower Sampler to depth; seat trigger clip into ramp on Dock Ring.G) Close and lock well cap.H) To sample, pull trigger cable while holding Dock Ring in place; remove trigger from dock and retrieve samplers.Well Head Dock Attachment(F) (G) (H)Hang Trigger Close Cap and SecureTrigger CableHold dock ring in place Sampler ID tagSlide trigger clip onto Dock Ring. Dock Ring “ramp” should face upward.while pulling trigger