Trapzilla - TZ-160 - Supercapacity Grease Trap System-Brochure

©2008 Thermaco, Inc. • All rights reserved • Patented/Patents Pending • Specifications subject to change without notice11/08 Thermaco, Inc. • PO Box 2548 • Asheboro, NC 27204-2548 • Phone: (336) 629-4651 • Online: www.big-dipper.com 1Trapzilla® Grease Trap SystemTZ-160 SpecificationsTECHNICAL DATAMaterials:Maximum Inlet Flow Rate:Grease Retention Capacity:Rotationally Molded Polyethylene35 GPM (2.21 l/s)160+ Pounds (72+ Kg)18” CLEARANCE FROMTOP OF TANK REQUIRED FOR LID REMOVALFEATURES:• Offers a flat grease separation curve• Constructed of corrosion resistantmaterials suitable for installation invirtually any location. • Compact footprint.InletOutlet®Conforms to ASME StandardASME A112.14.3-2000®2” Vent©2008 Thermaco, Inc. • All rights reserved • Patented/Patents Pending • Specifications subject to change without notice11/08 Thermaco, Inc. • PO Box 2548 • Asheboro, NC 27204-2548 • Phone: (336) 629-4651 • Online: www.big-dipper.com 2Trapzilla® Grease Trap SystemInstall “P” trap on outlet connection of tank. (Note: the unit already has an internal gas trap).DON’T . . .Reduce pipe size on outlet piping.DO . . .READ instruction manual included with system before doing anything.Install unit allowing for the minimum clearances shown.Make piping connections with rubber “No Hub” connectors.Keep outlet piping as straight as pos-sible. Use only “sweep” connections.Install vent on outlet piping.INSTALLATION INFORMATIONSuggested Minimum Footprint DimensionsNOTE: Drawing for reference only. Equip-ment must be installed in compliance with all applicable laws, regulations and codes, including plumbing codes. Installation should be performed by a qualified plumber.TZ-160 SpecificationsJob Specification:Grease and oils separator(s) shall be Thermaco Trapzilla hydromechanical grease/oil interceptor system(s) as manufactured by Thermaco, Inc., Asheboro, North Carolina as noted on plans.Separator Specifications:Furnish and install ___ Thermaco Trapzilla Model No. TZ-160, linear low-density rotationally molded polyethylene grease and oil separator(s) for below or above-ground installation, shall be ASME A112.14.3 Rated at 35 gallons (2.21 l/s) per minute peak flow, 160+ pounds (72+ Kg) of grease storage capacity with a flat grease separation efficiency curve, crush-resistant cylindrical walls, twin integral portals for access by grease pump truck for grease removal, single separate integral portal for vacuum access for removal of solids, self guiding pipe for pump truck access/solids removal, integral non-floatation anchor ring for in-ground installation, integral horizontal baffle, laminar inlet flow diverter, separate storage compartments for grease and solids, and including as an integral part of the unit an integral gas trap and a fully removable polyethylene self-positioning keyed cover equipped with sealed thread fasteners. The Grease Retention Capacity shall be not less than four pounds (4 lbs.) per one gallon (1 gal.) or 477 grams per 1 liter average flow rate. GREASE GRASAGREASE GRASASOLIDS SOLIDOSDO NOT USE MECHANICAL CRUST BREAKING DEVICESU.S. and International Patents Issued and Pendingwww. .comCAThe Trapzilla® requires 6” of clearance all the way around the lid from walls or other structures to allow for servicing.