Type 100M - Motorized Air Pressure Regulator Brochure

Type 100M Motorized Air Pressure RegulatorPrecise pneumatic control by use of an electronic signalThe ControlAir Type 100M Motorized Air Pressure Regulator isdesigned to provide precise pneumatic control by use of anelectrical signal. This highly accurate device is well suited forpneumatic control of a system from a remote location. Utilizingtwo tandem synchronous AC Motors, each having it's own setof leads, but operating through a single output shaft, direction ofrotation is dependent of which set of leads power is applied to.The motor is coupled to ControlAir's Type-100, which is a highprecision, multi-stage air pressure regulator with low powerrequirements.F E A T U R E S•Maintains SettingMaintains pressure setting in the event of a power failure•Low Power Consumption•No Pre-regulation of Supply PressureNecessary•Mountable at Any Angle•Adjustable Mechanical Stop Limits MaximumOutput Pressure•Flexible Range OptionsA variety of motor voltages, pressure change rates, pressureoutput ranges and ports sizes are available•Compact sizeOperationWhen no electrical power is supplied the regulator maintainsa precise set point despite variable supply pressureconditions and flow rates. When power is applied to themotor the regulator pressure output changes at approxi-mately a constant rate until power is removed.ApplicationsThe Motorized Type-100M is well suited for a variety ofapplications. It can be used in a centrally controlled system,or in areas not easily accessible to the operator such asventilation systems. It can be incorporated into open orclosed loop process control systems and may be used withprogrammable controllers.Type 100M DimensionsR E G U L A T O RFlow Capacity 14 scfm (25 m3/hr)at 100 psig (700 kPa) supply; 20 psig (140 kPa) outletExhaust Capacity [5 psig (35 kPa) above set point]Standard Regulator: 2 scfm (3.4 m3/hr)High Relief Regulator: 10 scfm (17.0 m3/hr)Total Air Consumption 0.10 scfmMaximum Supply 150 psig (1050 kPa) PressureTemperature Range 0° F to 140° F (-18° C to 60° C)Available Port SizesSee ordering informationand Output RangesM O T O RMotor Type Reversible, synchronous motor with gear drive and slip clutch.Torque Approximate 8 in. oz.Operating Voltage/See ordering informationFrequency/Speeds/Power ConsumptionR E G U L A T O R / M O T O RWeight 2.75 lb.8 Columbia Drive / Amherst, NH 03031 USAWebsite: www.controlair.comEmail: sales@controlair.com603-886-9400 FAX 603-889-1844Type 100M SpecificationsP/N 441-625-011 9/22/03Use this coding system to orderPressure RangeA - 2-40 psigB - 2-60 psigC - 2-120 psigD - .5-25 psig L.R.(Note: 50 psig max. supply)E - 2-120 psig H.R.Port SizeA - 1/8" NPTB - 1/4" NPTC - 3/8" NPT130Model•• Motor SpecificationsA - 2 RPM, 110 VAC, 60 Hz, 4 WattsB - 6 RPM, 110 VAC, 60 Hz, 6 WattsC - 6 RPM, 220 VAC, 50 Hz, 6 WattsD - 2 RPM, 24 VAC, 60 Hz, 4 WattsE - 6 RPM, 24 VAC, 60 Hz, 6 WattsF - 6 RPM, 24 VDCG - 6 RPM, 12 VDC•Typical Installation for Motorized Type 100M Control Circuit DiagramNote: Diagram for AC units only. DC units requirereverse polarity only. To decrease output pressure,apply voltage to unmarked leads. To increase outputpressure, apply voltage to marked leads.Ordering Information