WaterBetter - Model Polyester - Cartridges Brochure

Made in USAHARMSCO®WaterBetter ® Polyester Series CartridgesHighly efficient and economical filter cartridges made of pleated Polyester-Plus™ filter media.HARMSCO® Filtration ProductsIndustrial Water FiltrationCooling Tower FiltrationChill Water Loop FiltrationFood & Beverage FiltrationMarine / Aquatic FiltrationCommercial/Residential Drinking Water FiltrationMunicipal Drinking Water FiltrationReverse Osmosis Pre-filtrationDesalination Pre-filtrationPleated design for more surface areaFDA approved materials - NSF 61 certifiedEngineered media for superior performanceCleanable and reusable in most applications and micron sizesThermally bonded end caps to ensure better sealingColor coded end caps for easy micron identificationFull product line - largest selection of micron ratingsDesigned for HIF, BC and FSSS Filter HousingsLower overall operating costLonger filter runs for fewer change outsLower initial pressure drops Reduced maintenance down time and cost Increased contaminant removalHigh flow capabilityResidential / CommercialFeatures Applications Product Code NominalMicron RatingMedia(sq ft)RecommendedFlow Rate* (GPM)Length(in)O.D.(in)No./CasePolyester-Plus™ - engineered for high efficiency, low pressure dropsWB-1W* 1 4 4 9-3/4 2-3/4 24WB-5W* 5 4 4 9-3/4 2-3/4 24WB-20W* 20 4 4 9-3/4 2-3/4 24WB-50W* 50 4 4 9-3/4 2-3/4 24WB-921-1 1 8 8 19-1/2 2-3/4 24WB-921-5 5 8 8 19-1/2 2-3/4 24WB-921-20 20 8 8 19-1/2 2-3/4 24WB-921-50 50 8 8 19-1/2 2-3/4 24WB-20-1W* 1 8 8 20 2-3/4 24WB-20-5W* 5 8 8 20 2-3/4 24WB-20-20W* 20 8 8 20 2-3/4 24WB-20-50W* 50 8 8 20 2-3/4 24WB-931-1 1 12 12 29-1/4 2-3/4 24WB-931-5 5 12 12 29-1/4 2-3/4 24WB-931-20 20 12 12 29-1/4 2-3/4 24WB-931-50 50 12 12 29-1/4 2-3/4 24Four micron ratings and color coded end caps for easy identification.Low Pressure Drop With Harmsco® CartridgesPressure drops are exceptionally low with WaterBetter® Seriescartridges due to high surface area and Polyester-Plus™ engineered media. The data shown (left) is per new 9-3/4” cartridge in clean water.Filter media: Polyester-Plus™End caps: Plastisol (pliablePVC)Center cores: Molded ABS or rigid PVCTemperature: 140°F (standard cartridges) Flow rate: 3-5 GPMpH: 3 to 11Surface area: 4 sq.ft. per 9-3/4” length (approx.)Dimensions: 2-3/4” O.D.; 1-1/16” I.D.Graph colors (left) correspond with color codes (above) used to identify nominal micron rating of cartridge.Pressure Drop (PSI)Flow Rate (GPM)0.11 2 3 4 5 60.20.30.5Typical 5 Micron Depth Cartridge1520500.4Nominal Micron1 5 20 50End Cap Tan White Blue Yellow2-3/4” O.D.9-3/4”19-1/2”29-1/4”20”* “W” indicates wrapped.WaterBetter® Polyester Series CartridgesSpecificationsCartridge Selection/ Sizing GuideHARMSCO EUROPE SRL®Via Salvo D’Acquisto 10a-12 46040 Guidizzolo (MN) ItaliaTel: (0039) 0376 818782 • Fax: (0039) 0376 818399 • E-mail: info@harmscoeurope.com© Harmsco, Inc. 24A 3/11www.harmscoeurope.comMade in USANote: This publication is to be used as a guide. The data within has been obtained from many sources and is considered to be accurate. Harmsco does not assume liability for the accuracy and/orcompleteness of this data. Changes to the data can be made without notification. Temperature, Pressure, Flow Rates, Differential Pressures, Chemical Combinations and other unknown factors can affect performance in unknown ways. Limited Warranty: Harmsco warrants their products to be free of material and workmanship defects. Determination of suitability of Harmsco products for uses and applications contemplated by Buyer shall be the sole responsibility of Buyer. The end user/installer/buyer shall be liable for the product’s performance and suitability regarding their specific intended applications. End users should perform their own tests to determine suitability for each application.Harmsco® HIF filter housings use 9-3/4”, 19-1/2” and 29-1/4” length cartridges only.Cartridge Length