XC II Micro-Carbon II Series Filter Cartridges Brochure (PDF 51 KB)

Data Sheet 1657-2CXC II MICRO-CARBON® II SeriesFilter CartridgesGranular Activated Carbon Filter Cartridges for LiquidApplications• Contains Premium Grade, Low Sulphur Activated Carbon• Highly Effective at Removing Chlorine• Incorporates 20 Micron Nominal Post Filter to ReduceCarbon Fines and Particulate• End-to-End Flow Design Maximizes Carbon Adsorption• DOE End ConfigurationTypical Performance SpecificationsFilter Grade:20 µmRecommended Maximum Flow Rates1:1 gpm (3.8 lpm)Initial ? P (psi) @ Flow Rate (gpm):4.5 psid (0.3 bar) @ 1 gpm (3.8 lpm)Cartridge Capacity for Chlorine @ Flow Rate (gpm)2:7,500 gallons (28,390 l) @ 1 gpm (3.8 lpm)Maximum Operating Temperature:125°F (52°C)FDA Listed Materials:All polymeric materials are listed for food contact applicationsin Title 21 of the U.S. Code of Federal Regulations.Product SpecificationsMaterials of Construction:Filter Media: Granular Coconut Shell Based Activated CarbonOuter Shell& End Caps: PolystyrenePost Filter: Spun PolypropyleneGaskets: Buna NExpansion Pad: PolyesterDimensions (nominal):Outside Diameter: 2 7/8" (7.3 cm)Inner Diameter: 1" (2.5 cm)Length: 10" (25.4 cm)1 - For enhanced performance, operate at recommended flow rate.2 - Chlorine reduction data is for 2 ppm free chlorine to <0.5 ppm.3 - Fits PPS and NHP Series housings; does not fit LMOU and SCO Series housings.Liquid Flow Rate vs. Differential PressureFlow rate is per 10" (25.4 cm) cartridge. For liquids other than water, multiplydifferential pressure by fluid viscosity (cP).1.20.90.60.30DifferentialPressure(psid)Bar(x100=kPa)25201510501 2 3 4 5Flow Rate (gpm), Water at 68°F (20°C)Flow Rate (lpm)0 4 8 12 162200 Northern Boulevard.East Hills, New York 11548-1289 1.800.FILTERS toll free516.484.5400 phone516.484.3216 faxinformation@pall.com e-mailVisit us on the Web at www.pall.comPall Corporation has offices and plants throughout the world in locations including:Argentina, Australia, Austria, Belgium, Brazil, Canada, China, France, Germany, India,Indonesia, Ireland, Italy, Japan, Korea, Malaysia, Mexico, the Netherlands, New Zealand,Norway, Poland, Puerto Rico, Russia, Singapore, South Africa, Spain, Sweden, Switzerland,Taiwan, Thailand, United Kingdom, United States, and Venezuela. Distributors are located in allmajor industrial areas of the world.© Copyright 2005, Pall Corporation. Pall, and and Micro-Carbon are trademarks of Pall Corporation. ® Indicates a Pall trademark registered in the USA. is a service mark of PallCorporation.Bulletin #1657-2C 7/05ApplicationsTaste, TCE & ParticulateOil Vapor Organics Odor, Color Chlorine THM RemovalWater:Drinking 4 4 4 4Bottle Washing 4 4 4 4Rinse Water 4 4 4 4Single Pass 4 4 4 4Recirculating 4 4 4 4 Use Pre-filterChemicals:Single Pass 4Recirculating 4 4 Use Pre-filterGases:Air, Plant 4 4 4 Use Pre-filterAir, Instrument 4 4 4 Use Pre-filterAir, Breathable 4 4 4 Use Pre-filterGas, Compressed 4 4 4 Use Pre-filterWARNING:For drinking water applications, do not use with water that is microbiologically unsafe or of unknown quality without adequatedisinfection before or after the system.NOTE:Filter must be protected against freezing which can cause cracking of the filter and water leakage.CAUTION:These cartridges contain a very small amount of carbon fines (very fine black powder). After installation, flush the cartridge for aminimum of 5 minutes to remove all traces of the fines before using the water. You should run (flush) the tap at least 20 secondsprior to using water for drinking or cooking purposes. This is particularly important if the tap has not been used daily.Part Numbers/Ordering InformationC l P – XC II (e.g., C10P–XC II)Code Cartridge l Length(nominal)10 10"