AquiTron - Model AT-DTP -Water Leak Detection Drip Tray Probe

The AT-DTP sensor includes a stainless steel bracket to hook over the side edge of a drip tray to detect a small level of water within. Ideally suited for drip trays below air condition units, fan coil units, condensate pumps or any overfl ow/drip tray. For distributed applications, up to 100 probes may be interconnected by a single jumper cable (daisy chain) and monitored for leak location utilising either a TTDM-128 or TTSIM-1 / 1A / 2 alarm and locating module, providing leak location in either metres, feet or zones*. The AT-SZA and AT-MZA alarm panels can be used to provide a single or multi zone indication (see panel data sheets for maximum probe quantities). The AT-DTP probe is not suitable for permanent submersion.

Sensor Body Material: Brass, 3/4” BSP
Bracket Material: Stainless Steel 316
Maximum Operating Temperature: 100 C
Probe Tips: Coated Stainless Steel
Fly Lead Connection: 2 metres
Minimum Detection Height: 10mm with a 33mm tray depth (the minimum detection height will vary depending on the side wall height of the drip tray)
Mounting: Vertically by hooking the bracket over the side wall of a drip tray
Resetting: Remove whole sensor assembly from the water, dry and refit

Catalogue number

• 4780 AT-DTP Drip Tray Probe including Stainless Steel Bracket and 2m lead

Supporting Products

• 2595 AT-BCB For use with meterage location systems to give mapping points

Spares

• 4781 AT-DTP-BM Back nut
• 4782 AT-DTP-BRK Stainless Steel bracket only
• 2435 AT-600A Replacement sensor