- Home
- Equipment
Refine by
Air N Gas Environmental Equipment & Supplies
6 equipment items found
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
The simplest way of removing moisture from compressed air is to reduce the temperature. In Refrigerated Air Dryer compressed air is passed through a heat interchanger where cold refrigerant at around 3 Deg C is passed through the other side of the heat interchanger. At this temperature most of the moisture is condensed which is then separated and drained out in moisture ...
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
This is the simplest of all desiccant based air dryers. In this dryer, two desiccant towers are used. While one tower is in drying, the second tower undergoes regeneration simultaneously. Part of dry air coming out from tower in-line goes for regeneration of the second tower. Tower changeover takes place every 5 minutes by a sequence controller mounted in control ...
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
Heat of Compression type air dryer is a breakthrough in drying technology. The hot air from the Compressor at 140°C and higher temp, is used directly for regeneration of the desiccant. After regeneration, this air is cooled down to 40°C and then it is dried in second tower. Thus the use of heaters is eliminated. For eg. in the 6+6 Hrs. Cycle the hot air is fed for regeneration for 4 Hrs. ...
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
To save on purge loss, here part of wet air is circulated through a heater thereby increasing its moisture carrying capacity, which is used for regeneration. In this type of dryer incoming wet air is divided in a distributor. 60-70% of wet air goes for drying while 30-40% of wet air is circulated through a heater thereby increasing its temperature which then takes out the moisture from the ...
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
This is an improvised version of the heatless dryer where purge air loss is very very low due to regeneration is achieved by dry air at low pressure and at high temperature. To achieve this, heaters are provided to heat the purge air to around 180 Deg C, which enhances its moisture carrying capacities. This hot purge air at low pressure is passed through the desiccant bed to regenerate with a ...
Manufactured by:Air-N-Gas Process Technologies based inAhmedabad, INDIA
PSA ( Pressure Swing Adsorption) Technology a revolution in Non-Cryogenic Air Separation and Oxygen Generation Technology uses a special grade of ZMS ( Zeolite Molecular ...