- Home
- Equipment
Refine by
Ensepatec Environmental Equipment & Supplies
7 equipment items found
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
RainSep air/liquid separators from ENSEPATEC provide maximum protection against intake of rain, mist and most fog from wetting out downstream equipment and filters. Wetted filters will increase pressure loss and reduce the efficiency and life of the filters. Keeping your filter dry will ensure maximum performance and life of the filters minimizing maintenance cost and cost of operating the ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
Ensepatec provides the engineering and design of 3-phase separator internals that target high gas volumes and primary L/L dispersions. Our scope includes the design, engineering and delivery of a) The inlet gas distributor (1). b) The foam breaker along with the the L/G separator (5). c) The dimensional design of the inlet compartmeent, the settling compartment and the product outlet compartment ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
Ensepatec offers a broad selection of high performance separation internals for horizontal gas flows. These serve in a broad range of industrial, commercial and process ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
Salt particles, either solved in liquid or as dry crystalline state are the most unwelcomed visitors for your ambient air intakes and downstream equipment. If not controlled they will reduce the life of the duct system and downstream equipment due to their highly corrosive effects. Air-borne salt laden droplets are too small (1µm to appr. 600µm) to be completely eliminated with a ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
Ensepatec provides enhanced liquid/gas separation equipment for the safe and economical removal of liquid droplets from saturated steam inside a steam drum. The separation internals consist out of pre- and fine separation elements including axial and radial cyclones, flow distributors, vane type separators with coalescer pads for the removal of very fine droplets. Ensepatec designs and selects a ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
Ensepatec offers fully standardized, high-performance and energy-friendly, gas/liquid separations for vertical gas flows. The separators include designs for pre-separation (bulk entrain ment separation for 2-stage systems) and fine separation (to be used as a polishing stage for 2-stage systems or where the process conditions only require a single-stage device). The separators eliminate liquid ...
Manufactured by:ENSEPATEC based inWilmington, DELAWARE (USA)
The horizontal knock-out drum targets at applications with high liquid loads and fine removal efficiencies between 5 and 20µm. The length is dictated by the internal diameter (ID), the gas volume flow and the required efficiency. The horizontal KO-drum accommodates internals such as inlet gas distributors, perforated plates, vane type separators and coalescing pads. The separator is split ...