Sukup - Drag Conveyors and Hy-Flight Incline Conveyors

Both versions of the conveyor feature:

• Conveyors run clean and dry due to the exclusive patented cover design
• Single assembly bearing, sprocket and shaft saves time if maintenance removal is required
• In case of wear, the floor panel can be removed separately without replacing the entire body
• Long wearing heavy duty pillow block bearings on both the head and tail of the conveyors
• Heavy duty construction throughout produces long wearing drag conveyors
• Turned, ground and polished shaft ensures minimum friction and wear
• 1/2 “UHMW paddles eliminates wear from steel to steel contact
• Corrosion- resistant Acme thread take-up screws at the tail of the conveyor
• Available in 6’, 8’, and 10‘ length, adjustable shroud on by-pass drive-over hoppers controls grain flow
• By-pass inlet hoppers are available in 2`, 3` and 4` lengths.

• Modular curve section allows curves from 10 degrees to 50 degrees in 5 degree increments.
• Optional abrasion-resistant liners on sides available in 10 gauge or 3/16".
• Optional abrasion-resistant bottoms are available in 3/16" or 1/4" thicknesses.

• Abrasion-Resistant Liners on sides are offered in 10 gauge and 3/16".
• End relief Door prevents damage to the conveyor in the event of a discharge plug.
• Rail Return comes standard on 21" wide or wider conveyors. Optional on 12" and 16" wide conveyors.
• Reversing feature can take grain in multiple directions and is a great addition if you are looking to unload into two separate bins.
• By-pass drive-over hoppers have an adjustable shroud to control flow and are available in 6`, 8` or 10` lengths.
• By-pass inlet hoppers are available in 2`, 3` and 4` lengths.
• Intermediate discharge gates can act as a separate discharge location from the head and are made up of 7 gauge construction.