EFS - Model IFR 1500-6000 -Instantaneous Flowmeter
The Step-By-Step Flowmeter for the Instantaneous Flow Measurement and the Injection Rate. The latest in our range of flowmeters, the IFR 1500-6000 model allows the measurement of injected volumes or mass but also the step-by-step injection rate. It is used to control diesel, kerosene, and heavy fuel oil engines. Due to its very compact design, this flowmeter can be very easily integrated into a study bench or a 6 or 12-way production bench (mounting under the cylinder head possible).
In Research or Development or for production applications of injectors for trucks, boats, construction machine or trains, it provides a very detailed analysisof the injector (opening or closing time, start and length of injection, opening and closing speed of the injector).
QUICK SETUP
A mechanics with electrical and hydraulic connections gathered at the back of the flowmeter, 2 electrical cables and a controller to be installed
COMPACT
Reduced size (383 x 266 x 701 mm), possibility of installing 6 IFR under a cylinder head.
ACCURATE
Very accurate measurements of the injected quantity and of the injection rate at each revolution up to 0.5 mg of precision and 1 µs of discrimination
COMPREHENSIVE
A single equipment for a very detailed analysis of the injection with measurement of the quantity and the injection rate. Instantaneous values, minimum, maximum, standard deviation…
- Real time measurements updated with each injection allowing to follow with extreme precision the evolutions of all the injection parameters and to deliver representative statistical results.
- Instantaneous flow measurement up to 10 injections / revolution.
- Real-time display of the injection rate curve
- Several automatic and manual cursors for detailed temporal and mass analysis.
- Measures largely independent of pressures, quantities, and timing of injections.
- Adjustable back pressurefrom 10 to 200 bar without external equipment. Back pressure generated by the injector.
- Configurable measurement window from 90 to 270 ° pump(180 ° to 540 ° motor).
- Pump speed range from 30 to 3000 rpm (0,5 Hz to 50 Hz).
- Solid measurement stability in transients and low hysteresis.
- Full integrated injector pilot generator (1 to 10 injections per revolution, ramps, etc.).
- Automatic analysis of very effective injections (separation of a very small injection close to a large injection, discrimination of pre- and post-injections).
Compact ready-to-use set consisting of the following:
- Electronics managing the measurement cycle and carrying out all the calculations at each turn.
- Une rack électronique gérant le cycle de mesure et réalisant l’ensemble des calculs à chaque tour.
- Two 8 meter cables.
- An Ethernet link for connection to the PC
- xIFR software (for Windows)
- Truck
- Boats
- Train
- Construction machine