ENVEA - Model PCME STACK 602 -Dynamic opacity Approved Particulate CEM

• Simple installation, set-up and maintenance
• Resistant to contamination, operational with optics 90% contaminated
• Lower levels of maintenance than traditional opacity systems
• Can be purged with instrument air providing lower cost of ownership; blowers available if preferred
• Used for compliance measurement (mg/m³) after electrostatic precipitators and baghouses
• Advanced sensor design includes automatic drift (zero and span) checks mg/m³ output, once calibrated.

• Stacks after bag filters, cartridge filters, cyclones, electrostatic precipitators, no filtration
• Non-condensing / dry flue gases

Typical Applications:

• Incineration
• Metals (eg Steel/Aluminium)
• Minerals (eg Cement/Gypsum)
• Chemicals (eg Refinery / Rubber)
• Power Generation Plant (eg Coal/Biomass)

• Measured parameters: Dust
• Technology: DynamicOpacityTM
• Measurement/Monitoring capability: <10 – 1000 mg/m³*
• Stack/Duct diameter suitability: up to 15m
• Flue gas temperature: up to 600°C
• Baghouse: YES
• Cartridge Filter: /
• Ceramic Filter: /
• Coalescent Filter: /
• Cyclone: YES
• Electrostatic Precipitator (ESP): YES
• Wet Electrostatic Precipitator (WESP): /
• Wet Scrubber: /
• Sensor variants: Stainless Steel
• QA checks: YES

• Measurement capability: <10 – 1000 mg/m3
• Sensor Variants: 316 Stainless Steel (head and coupling)
• Stack Temperature Ranges: -25°C -250°C (standard) up to 600°C (option)
• Functionality and QA Checks: Automatic zero, span and light checks
• Interface: Available with standard control unit (Interface module) for single stack or with ProController for multi-sensor networks
• On-board data logging: User configurable, Long term, Short term or Pulse logging
• Output: RS232, RS485 (Modbus), Ethernet Digital Alarm and 4/20mA (number of outputs dependant on controller type)
• Air Purge: instrument air or blower
• Enclosure Protection Rating: IP65

• TÜV approved