Techno-AC - Model CI-XXX -Induction Clamps

Application

Above all, inductive clamp CI-110, CI-110/50, CI-110/110 and CI-110/125 are used for:

• Firstly, contactless induction of signal into cable or conducting line.The signal should have specific frequency and limited power, generated by AG-105 or AG-120 location transmitter (AG-105 uses specific CI-105 clamp).
• Secondly, external locating receiver sensor when it is necessary to locate the cable in a bunch.

Operation method for CI-XXXCable location (including lines under voltage)

• Firstly, connect induction clamp to output socket of the transmitter.
• Secondly, set the type of generation (pulse or continuous) and select signal frequency.
• Further, brace the cable with clamp. Make sure, both half-rings touch each other.
• Meanwhile, start the generation on transmitter.
• In addition, select transmitted frequency in location receiver settings menu and locate the utility.
• Subsequently, finishing the location, stop the generation on transmitter.
• After that, remove the clamp from the cable.

Selection of the cable from a bunch

• Firstly, induce tracing signal of test frequency on selected cable.
• Secondly, select same frequency as on transmitter in locating receiver menu and locate the cable.
• In addition, connect inductive clamp to locating receiver.
• Consequently, brace each cable one by one in a bunch. Maximum signal level on receiver screen will indicate the cable you are looking for.

Mostly, pliers are used to transmit a signal to a cable or metal pipe. In the event that this route is without voltage and there is no way to produce insulation for the signal.

Moreover, they can be used as a sensor to receive a signal from a line. In this case, the connection of ticks is made to the receiver. Such dual use significantly reduces the cost of this equipment.