Non-Slip Coating - Traction-N-More Epoxy Master Kit

To apply: Simply clean surface, mix up 2 part paint, roll down, broadcast the aggregate over it in a uniform fashion and let it dry 24 hours for foot traffic and 48 hours for vehicular. This 100% Epoxy Non Slip coating Kit can be used to help prevent accidents on sidewalks, ramps, trucks, production areas, driveways, basement floors, bricks and stones, steps and more. Excellent for use on floor areas which are subjected to abrasive traffic, impact and/or corrosive spillage. Easy to apply, yet tough enough to stand up to heavy vehicular traffic - even fork lift trucks.

This permanent non skid coating with its powerful industrial sand paper like finish saves down time by reducing slippery areas in any work environment even if wet or covered in liquids. (Epoxy Non Slip Coatings are Available in a variety of colors as well as custom matched floor colors as close as possible.) Low odor and easy to clean for use indoors and outdoors on sidewalks, decks, walkways, floors, concrete, steel/metal ramps, equipment and much more. ***Just a note-Please make sure "you want it where you apply it" as it is extremely difficult to remove once it dries.

• One Master Kit Covers Up To 600 Square Feet Depending on the Porosity of the Surface Being Treated.
• Available in Standard and Custom Colors

Start with a clean, dry surface. Mix up the 2 part (Part A, Part B) non-slip paint in its entirety. Use a paddle attachment on a corded drill and mix for 5 minutes or better, let stand 10 minutes and roll onto surface. (Medium knap roller recommended) The aggregate can then be broadcast over the freshly painted area.

This will vary on temperature and relative humidity. 24 Hours for Foot Traffic. 48 Hours for Vehicular Traffic.