Logo Environmental XPRT
Companies
Products
Services
Software
Training
Applications
Sign in
List your business
AB Micatrone
About
Downloads

Micatrone - Model MFM -Panel

SHARE

Remove the protective foil from the panel. Mount four pieces of threaded spacers 70mm with the M3x8 screw on the panel according to figure.

Most popular related searches
heat protection
  • Fit the panel with the mounted threaded spacers into the cabinet bottom part so that the spacers threads point out at the backside. Mount four nuts (M3) with washer without tightning them.
  • Mount the cabinet front on top of the panel so that the panel is being centered to the cabinet, tighten the nuts on the backside of the bottom cabinet part. Do not tighten too hard since this may cause the spacers to cut into the plastic of the cabinet inside and an uneven mounting of the panel plate will occur.
  • Cut or saw out a squared hole for the apparatus of 124x122mm (width x height) in the cabinet door. Drill four holes for mounting the panel according to the measurement on next page figure. Note! When using the attached machine screw (ST4.8x9.5) the hole should be with a diameter of Ø3.9 mm. If using the metric screw M5x10 the diameter of the holes should be drilled to a diameter of 5.5 mm to allow some adjustment.