Pasco - Model ME-7034 -General Purpose Rotation Pivot Device

This Pivot is used as a fulcrum in meter stick torque and as a rotation device for rotational inertia experiments.

• 1x Pivot
• 1x 3-step Pulley

This Pivot can be used two ways:

1. As a fulcrum in a meter stick torque balance: It can be mounted so the shaft is horizontal for use with the Meter Stick Torque to do torque experiments or to do pendulum experiments.
2. As a rotation device for rotational inertia experiments: It can be clamped on a horizontal or vertical rod. It can also be mounted with the shaft vertical so it can be used as a rotational base for the Rotational Inertia Set (ME-3420). 

The Pivot has a 1/4-inch diameter shaft out both sides which rotates on two ball bearings. To record data, use with a Smart Gate (or any standard photogate) and pulley.

• Slotted shaft extends in two directions
• Built-in rod clamp for mounting horizontally or vertically
• 3-step pulley for applying torque
• Fits Rotary Motion Sensor accessories such as the Rotational Inertia Set (ME-3420)
• Ability to mount at any height

• Meter Stick Torque
• Rotational Inertia
• Physical Pendulum
• Centripetal Acceleration

• 1x Pivot
• 1x 3-step Pulley

Slotted Shaft:

• 1/4-inch (6.35 mm) diameter
• 16 mm length (both sides)
• Both ends are threaded for the included 6-32 screw
• Shielded Ball Bearings: 2
• Case Dimensions: 4.0 x 4.1 x 7.3 cm
• Built-in Rod Clamp: Fits up to 1/2-inch (12.7 mm) diameter rod