Poly-Cam - Model 701 -Transition with Cut Groove

Design
The relaxation creates a seal to prevent leakage. Under pressure, the internal pressure within the pipe increase the sealing surface area on the barb. Under zero internal pressure, the compression strain and tensional strain created by the compression of the multi-level barbs is greater then the stress created by relaxation and/or thero expansion and contraction. As the internal pressure increases the joining of the polyethylene or copolymer and the coupling increases.

Sizes range from 1” to 24” Iron Pipe Sizes.
Grooves are cut to standard cut grooves specification.

System Performance
The transition fitting is designed to handle the pressure rating of the HDPE pipe with a 2:1 safety factor at 73.40 degrees Fahrenheit with a minimum 50 year design life.

Quality Assurance
The transition fitting shall be manufactured by Poly-Cam, Inc.
Poly-Cam, Inc. shall provide quality assurance with regards to proper installation, compatibility, performance, and acceptance.
Transition joint meets or exceeds the requirements of ASTM D2513 Category 3.
Upon request Poly-cam can install a stainless steel insert to meet ASTM 2513 Category 1.
All Fittings meet ARRA requirements.

Installation
HDPE pipe end: Install transition fitting so as to comply with the pipe manufacturer’s recommended procedures. All field welds shall be accomplished in accordance with Plastic Pipe Institute’s welding procedure for butt fusion.

Steel Fitting: The entrance of the coupling is tapered at the beginning. The Polyethylene or copolymer material is cold pressed into the coupling. This allows the material to relax into the patented multi-level barb system.

Material
The POLY-CAM Threaded Transition is manufactured of Carbon Steel (A53 or A106 grade) and incorporated with the transition manufactured of HDPE (cell class 345454c)or pipe quality Copolymer material. All certification will be submitted upon request.

The epoxy coating (IF 194T Red Iron Oxide ) is fusion bonded to the metal. It has approvals
NSF 61, FDA 175.300, AWWA C116-01,C213-01, UL 262 and FM 1120/1130
The carbon steel epoxy POLY-CAM threaded transition fittings complies with AWWA and NSF 61 material requirements.

Warranty
Warranty period is one year after date of substantial completion of installation.