Cavity Eye - Model RC15 and PC26 -Pressure Sensors

The pressure sensors operate on an electro-resistive principle, which is one of the oldest and most stable measuring methods. Cavity Eye uses only indirect sensors. From our experiences, the indirect measurement is much more precise, than the direct measurement. Using indirect measurement results in no need for sensor maintenance during the whole lifetime of the mold. Thanks to the sensor geometry we designed, the sensor installation is as easy as it gets! The final form of the sensors was achieved with years of hard work and development, so you get the most reliable source of information about your mold.

The brand name of the new type sensor is RC, which refers to Ring Cell because the sensors have a rubber ring around the diameter of the sensor which is aiming to help the following:

• Simplify the mold modification process
• Eliminate the fitting problems caused by the radius of the bottom of the sensor pocket
• More precise positioning of the sensors inside the pocket
• Enables smaller manufacturing precision and larger tolerances

Every sensor type has an item number, for example RC-15-1— where RC refers to the type of the sensor, 15 refers to the diameter of the sensor in mm and the last number refers to the maximum load: 1 kN. The possible two characters at the end of the code refers to the operating temperature of the sensor. Every sensors has a high-temperature range variation (HT) which is capable of measuring up to 200°C.