- Home
- Companies
- Faster Hot Water
- Products
- WaterQuick - Model Standard - Tank ...
WaterQuick -Â Model Standard -Tank Water Heaters
The WaterQuick - Standard hot water circulation system is the first "true on-demand" hot water circulating system for existing and new homes that delivers hot water when a hot water faucet is turned on.
- Faster Hot Water - less than a cup of water is wasted
- Faucet Activated - no buttons or remotes
- Installs at the water heater - not under a sink
- Easy install - DIY or Pro installation
- 3-year warranty
- Customer service - friendly and knowledgable
No wasting water down the drain saving:
- Water
- Sewer
- and Energy
A small, high speed, ultra-quiet hot water circulation pump is installed on the hot water outlet of a tank or tankless water heater.
ABridge Valveconnects the hot and cold water supply lines under the most remote kitchen or bath fixture in the house.
When the integratedFlow Managerdetects hot water use anywhere in the house, it turns on the hot water pump.
The cool water that normally would go down the drain is circulated back to the water heater through the cold water line.
TheBridge Valvehas a built-in temperature sensor that closes when hot water reaches the farthest sink.
Unless a hot water faucet is on theWater Monitorwill turn off the pump because hot water is everywhere you need it!
On-Demand Operation
A demand from any hot water faucet or appliance in the house will start the pump.
- No buttons
- No remotes
- No motion sensors
- No timers
All Water Heaters
The system can be installed on top of a tank style water heater or in-line with a tankless water heater.
- No pumps under cabinets
- No new electrical outlets
Whole House Solution
One pump with one or more Advanced Bridge Valves handles the entire home.
- Lower costs for homes with multiple dead-end plumbing lines
Virtually Maintenance Free
Constructed of high quality stainless steel and low-lead brass ensures years of maintenance free operation.
- Virtually eliminates call backs
- 3 year manufacturer`s warranty
New or Retrofit Installation
3 speed pump means 1 size fits all homes with plumbing lines up to 200` or more.
- No extra water lines in new homes
- Uses existing water lines in older homes
Circulation Pump:
Our high speed pumps are a custom designed component of our hot water circulation systems and include the following:
- 3/4" fittings
- 3 speeds - I, II and III, with III being the highest speed.
- Made of stainless steel
- Equipped with a 3 position rocker switch to switch the operation mode from Auto (controlled by the Flow Monitor), Off and Move (run full time for troubleshooting purposes)
- 10` electric cord (110 vAC)
- Backed by our 3 year warranty
Flow Monitor:
- 3/4" fittings
- Minimum activation approximately 0.17 gpm (about the flow rate when a drip becomes a stream)
- Made of lead free brass
- Powered by the pump electrical cord
- Backed by our 3 year warranty
Advanced Bridge Valve:
- Bridge Valve with an internal temperature sensor that closes the valve at 90 degrees and a check valve that prevents cold water from moving into the hot line.
- 2 - custom shut-off valves
- 2 - custom stainless steel supply lines
- Made of lead free brass
- Backed by our 3 year warranty
Dead-End Plumbing Layouts
1 - Dead-End Line
- 1 - Dead-end plumbing line
- 1 - Advanced Bridge Valve (comes with kit)
2 - Dead-End Lines
Tank water heater with:
- 2 - Dead-end plumbing lines
- 2 - Advanced Bridge Valves (1 - comes with kit)
Dedicated Return Line Layouts
1 - Dedicated Return Line
- Tank water heater with: 1 - Dedicated return line
2 - Dedicated Return Lines
- Tank water heater with: 2 - Dedicated Return Lines
