Althena - Conception and Design Service

After receiving an initial agreement from the customer on the feasibility analysis, we propose two or three technical solutions. Our experience, our sector and trans-sectoral knowledge allow us to always find the technical solution that best suits the preliminary analysis shared with the customer. We often employ concepts and solutions deriving from sectors neighbouring our own whilst apparently distant from us.

Once the design has been chosen, it is shared with the customer, in order to proceed with the creation of 3D prototype moulds that optimise the proposed design. The first laboratory tests, usability tests, etc then begin. From the results of these tests, new 3D printing prototypes are created, until the optimal design is obtained after several steps, which will then be produced via injection moulding.