EzyDrain - Installation Services

HOW TO FIT THE EZYDRAIN TWIN FIN

1. Ensure the twin fin is complete with base and flap top inserted and securely locked into position. You may install the base separately for hard to reach areas.
2. Remove the grill from your floor waste and clean any debris or dirt away with a brush, cloth or sandpaper if necessary to prepare the pipe.
3. Insert the EzyDrain holding it on a 180º angle (side on) as shown. For a firm grip, place two fingers through the lid then straighten and level the EzyDrain by tilting one corner. Fit the flap top lid if removed previously for installation.
4. Allow the upper fins to lay neatly on the interior of the pipe. To ensure the fitting is at optimum performance level pull the EzyDrain up towards you by placing your two fingers into the core and raise it to 1cm above the desired final position.
5. Press your EzyDrain down 1cm to the desired level in your pipe. This extra fitting procedure guarantees the bottom fin to curl correctly forming a tight “ring like” seal against the wall of the pipe.
6. Finally Check your EzyDrain flap top lid is locked into the base securely before replacing your floor waste grill.