Fabritek Company Inc
  1. Companies
  2. Fabritek Company Inc
  3. Services
  4. LD Rhino - Maintenance Service

LD RhinoMaintenance Service

SHARE

Fill hydraulic oil reservoir with 30 gallons of hydraulic tractor oil. MAKE SURE VALVES ARE OPEN at the bottom of the reservoir BEFORE STARTUP.

Most popular related searches
  • Fill engine with one quart of 30 weight motor oil
  • Fill gas tank with 20 gallons of gasoline 87 octane or higher
  • Apply gear lube to drive chains
  • Grease all zerk fittings (the top head, mast hinges, pillow block bearings and walking beam sheave axle) and mast hinges
  • Apply grease to walking beam sheave axel on both sides of the mainline cable sheave
  • After first two hours of drilling: torque all chain and pulley hubs to specifications
  • Grease walking beam sheave axle
  • Inspect for loose fasteners and tighten if loose
  • Inspect cable connections for wear and reconnect if worn
  • Inspect chain and belt tension and tighten if necessary
  • Inspect gas filter and replace if dirty
  • Inspect all jacks for cracks and repair with welder if necessary
  • Check for hydraulic leaks and check hydraulic oil level
  • Inspect rubber top head springs for damage
  • Grease all zerk fittings until seals expand. Avoid over greasing
  • Oil drive chains with gear lube
  • Pour some used motor oil over the mainline and sandline cables to prevent rust
  • Check tires
  • Grease mast cable guides applying ample grease by hand
  • Grease throttle cable push/pull rod
  • Clean hydraulic rams before lowering mast
  • Change engine oil and save for lubricating cable
  • Grease zerk fittings on jacks
  • Replace hydraulic oil filter
  • Remove cables and reverse them on cable spools to extend cable life
  • Inspect mainline brake pads and replace if necessary
  • Replace mainline cable if worn
  • Replace sandline cable if worn
  • Change hydraulic oil
  • Replace hydraulic pump coupler if worn
  • Adjust hand brake tension
  • Adjust flywheel belt tension
  • Adjust roller chain tension

Estimated life of the hydraulic pump and motors is 3000 hours.
Engine life expected is 3 years