Namirial - Version SISMOSPRINK -Static and Seismic Supports Design Software

Namirial SISMOSPRINK software, in fact, allows, through an intuitive and user – friendly input, to set up an advanced design of seismic and static supports for fire protection networks, both sprinklers and hydrants.

Thanks to a guided and error-proof procedure, it allows you to perform both the classification for the framework of the chosen reference standard, and the automatic identification of seismic parameters thanks to a G.I.S. (Geographical Information System) fully integrated into the software.

From the analysis and evaluation of the seismic loads of the project, all the components and related quantities necessary to create the clamping system are then identified during the calculation phase and on the basis of the project parameters entered. The components are specially and automatically selected by the software from the specially prepared archives with all certified Hilti products.

From anti-seismic and static collars, up to nuts, passing from rails, dowels and all the components necessary for the realization of the anchors suitable for the seismic and static load of the project, SISMOSPRINK takes you by hand to obtain a complete sizing of quantities and installation schemes.

SISMOSPRINK performs a calculation according to the chosen standard and automatically defines, thanks to the archives, the main adequate components, in terms of seismic force and traction, automatically creating a detailed report with quantities, pieces, and references to the products.

The program is also able to report anomalies in the calculation of incorrect sizing and allows, in the final phase, to readjust and modify the pieces chosen automatically or, with a few simple steps, to modify the project, with the subsequent recheck of the correct sizing.