Stormwater Management Applications

16 Results found
Only show results available in Virginia?
OK
  • Category: Water & Wastewater ×

  • Subcategory: Stormwater Management ×

Soil Stabilization

by Geo Products, L.L.C. - EnviroGrid Cellular Confinement (Geocell)     based in Houston, TEXAS (USA)

Problem: Poor load-bearing soils pose a significant problem for transportation and construction needs. Unpaved areas, such as access roads, paths, parking lots, driveways, etc can be highly vulnerable to near-surface shear failure and rutting, especially in moist conditions or areas with higher expected loads. Typically, engineers bridge over weak soils with rigid structures such as thick, reinforced concrete for roads and highways. However, such techniques are prohibitively expensive and inordinately difficult to install. The poorer the quality of the sub-base and the heavier the expected loads, the greater the amount and better the quality of support required.

Solutions for irrigation flow monitoring in submerged culverts

by Greyline Instruments Inc.     based in Long Sault, ONTARIO (CANADA)

Greyline DFM 5.0 Doppler Flow Meters with waterproof ultrasonic sensors measure flow in submerged concrete culverts in the Raymond Irrigation District in Alberta, Canada.

Dust monitoring and Sand Storm Monitoring

by Ecotech Pty Ltd     based in Knoxfield, AUSTRALIA

The frequency and intensity of dust and sand storms in many parts of the world are steadily increasing due to droughts and climate change. The severity of such storms is anticipated to increase over the coming years. These dust storms may last hours or days and cause huge damage and imposed a heavy toll on society with its physical effects, such as visibility reduction, heavy winds, red sky, hailstone and severe lightning. Such Dust storms, have a negative impact on human health, and industrial products and activities. They reduce visibility, layer on skin and cloths, infiltrate buildings and find their way into food and drinking water leaving a permanent sandy feeling in your mouth. Traditional dust monitoring instruments whether they be purely filter based gravimetric samplers or continuous monitors utilising Tapered Element Oscillating Microbalance (TEOM) or Beta Attenuation (BAM) simply are unable to cope with the high dust loads created by these storms. The filters on these instruments are quickly clogged and no further measurements are possible until a service technician visits to replace filters and filter tapes. In dust storm events this is impossible. Therefore, over the past few years a need for alternate technology which are non filter based, can cope with extremely high dust loads, require minimal maintenance and can operate off solar power has been employed in regions such as the Gobi Desert of China for the continuous monitoring of dust storm events. These instruments have demonstrated that an instrument can measure dust storm events with maintenance performed only once every 12 months. That it is possible to communicate remotely and that these systems can not only provide an early warning for dust events but have the accuracy and sensitivity to be an extremely useful tool in gauging hourly changes of visibility. Infact such instruments have been utilised by a number of EPAs around the world, including all Australian EPAs for the purpose of measuring ambient visibility as well as providing an accurate indication of rising dust events.

OneRainware™ - Radar rainfall for real-time and analytical applications.

by OneRain Incorporated     based in Longmont, COLORADO (USA)

Accurate estimation of the spatial distribution of rainfall is critical to successfully model hydrologic processes. OneRain has worked with engineering firms and those with responsibilities in Stormwater and Wastewater Management across the U.S. to provide radar rainfall data to help characterize storm events or flow problems in collection systems and as a basis for both real-time and design-oriented modeling. OneRainware products and services offer: *Real-time gauge-adjusted radar rainfall (GARR) data *Real-time area-average rainfall *Real-time forecast rainfall *End-of-month archive quality gauge-adjusted radar rainfall data *Historical and post-event analysis using archived rainfall estimates *Web-delivered calibrated radar-rainfall data *StormProperties™ Analysis. GARR data are used in flood warning, runoff modeling, basin modeling, I/I studies, litigation, real-time control, design storms, and National Pollutant Discharge Elimination System (NPDES) compliance activities.

Geosynthetic Lining for Highway and Civil Applications

by CETCO     based in Hoffman Estates, ILLINOIS (USA)

GCL can be used in highway and civil applications such as at airport de-icing facilities used to remove ice build up on the surfaces of planes. During the application process, glycol-based de-icing fluids can leak into local stormwater runoff, potentially causing pollution. CETCO GCLs were found compatible with de-icing fluid (glycol diluted 50/50 with water). GCLs can also be used to line roadway drainage swales for containment and prevent excessive percolation, thereby minimizing potential for groundwater contamination. Another example of using GCL in civil and highway applications is using the liner to contain acid rock and prevent runoff from entering the local water supply.

Towns wastewater treatment

by Sistema Azud, S.A.     based in Alcantarilla, SPAIN

Towns wastewater, including water generated by domestic use, by shops, public cleaning and storm runoff, must be adequately treated to meet the discharge requirements of public channel, or reuse as irrigation water mainly.

Inspection of throttle equipment for hydraulic inspection

by NIVUS GmbH     based in Eppingen, GERMANY

Definition of Task: Metrologic inspection of throttle equipment according to German self-control ordination (EKVO). Verification of approved pipe volume of Q = 10 l/s (readings must not vary by more than 20 % from reference value).

Stormwater Piping Systems / Stormwater Drainage

by ISCO Industries, LLC     based in Louisville, KENTUCKY (USA)

A high-quality drainage system is imperative for a strong infrastructure.  The integrity of roads, thoroughfares, parking lots and other paved surfaces depend on a reliable drainage system underneath to keep them intact.  ISCO has been helping solve customer`s drainage issues for years.  From the initial engineering planning phase to the finished product, ISCO is able to help.  ISCO offers all the pipe and fittings for any of your drainage projects. Selecting the longest-lasting, durable and cost-effective piping products is a key step in storm water management. To help you choose the best option for your project, ISCO Industries supplies HDPE, PVC pipe as well as perforated and HDPE corrugated tubing drain tile for storm water management applications.

Solutions for Stormwater management

by Invisible Structures, Inc.     based in Golden, COLORADO (USA)

Invisible Structures, Inc. is dedicated to providing a TOTAL STORMWATER MANAGEMENT system for your site. Our products offer economical and innovative solutions to meeting your NPDES Phase II and local requirements. Our product line will not only make post-development stormwater runoff equal to pre-development runoff, we will enhance the quality of stormwater by filtering and removing pollutants.

Flow measurement at overflow sill for stormwater treatment facilities

by NIVUS GmbH     based in Eppingen, GERMANY

Application: Pipe with 1.5m diameter, overflow on the side. Part filled. Pipe made of concrete.

Storm water flushing for sewage wastewater treatment

by Process Wastewater Technologies LLC     based in Rosedale, NORTH CAROLINA (USA)

With the increased use of storm water retention tanks, the need arises to routinely clean the tanks. Regular cleaning maintains combined sewer overflow (CSO) capacity and prevents septicity and odor problems associated with stagnant effluent. PWTech® Tipping Buckets provide a simple yet robust solution for flushing retention tanks.

Need help finding the right suppliers?

Let the XPRTs do the work for you