Brumby Pumps products

Low producing, high iron, high salt and high sand wells and bores are now easily produced. Medium production and remote wells/bores can also be produced, where before they were un-economic. The Brumby Pump is ideal for bores and wells - from very low producing to in some cases as much as 8000L/hr. Depending on submersion/lift ratio, the Brumby can naturally find an equilibrium at around 25 - 30% of total vertical lift (pump inlet to delivery pipe outlet).

That can be caused by drawing in dirt from the water bearing zones, depositing it down the bottom and blocking off some of the slotted casing, reducing the volume of water entering. It can also severely affect most submersible pumps by blocking them up, wearing them out or burning out motors. As long as the water in your well is not too deep (over 180ft or so of actual water column, depending on available air pressure), you can actually easily clean out your bore/well using a Brumby S1 or XS1 pump using a regular air compressor.

Water depth is and remains over 1/3 of the total vertical lift. The deeper you can submerse the pump in water, the more it will deliver.

Water depth is and remains over 1/3 of the total vertical lift. The deeper you can submerse the pump in water, the more it will deliver. Water level self-regulates by virtue of the pump`s design and operating principle.

Flow switch with 3/4 inch female threads. Suitable for water and air.

Brass flow switch, 3/4 inch female threads. Suitable for water and air.