Envirosoft Ltd. software

CEMForm is the primary application for viewing instantaneous data and historical trends, consisiting of the primary overview page, trend page and the data grid. The application also handles most of the data processing, such as normalisation and QAL2 factors. 

CEMPort provides generalised report production, i.e. non-specialist reports to summarise the emission data into daily, weekly, quarterly or yearly time periods. It may also be used to export the emissions data into a spreadsheet compatible format (e.g. comma separated variable - .CSV) and to check on any excursions above alarm levels which can be useful for external comparisons. All averages are available, from raw data (every few seconds) to an annual average. Typical statistical analysis including: maxima, minima, standard deviations, percentiles, operating time, mass release etc.

CEMQual allows the user to collect and review their QAL3 results in various different formats, such as an array of charts (SHEWART, CUSUM, EWMA or VCR) or as a data grid. QAL3 is a procedure for maintaining and demonstrating the quality of the Automated Measuring System (AMS) results during ongoing operation.

CEMCam provides a constant watch on the visible emissions from chimneys. Using a high specification webcam, and custom designed software, operators have the ability to quickly scan many hours of images to pinpoint potential problems.

CEMPact has been designed to operate in parallel with our Continuous Emission Monitoring System (CEMS) to provide an estimate of the ground level gas concentrations resulting from the release of exhaust gases from one or more stationary sources at a particular location. CEMPact calculates the mass emission (kg/hr) from the raw emissions data, & then uses the wind speed & direction, ambient temperature, stability class, stack gas temperature etc, to calculate the predicted pollution levels over a selected area. 

The Siemens panel program is a command interface and remote display for the following Siemens ELAN interface analysers: ULTRAMAT 6, OXYMAT 6, FIDAMAT 6, ULTRAMAT 23. By using the Siemens panel program, the operator can change and observe the parameters as if at the analyser keypad. Such data includes: diagnostics, current output, calibration times etc, and commands such as calibrations and pump operations are included.

This utility has been developed alongside Land to provide a valuable diagnostic tool for the Land FGAII gas analyser. Operating on the PC in parallel with CEMSuite, Land Panel can provide detailed knowledge of the analyser operation, assisting in maintenance requirement assessments