Fine spol. s r.o. software

GEO5 is a software suite, providingsolution for majority of geotechnical tasks. Individual programs have the same user interface and communicate with each other, whileeach program verifies definite structure type.

This program, based on the finite element method, can model and analyze a wide range of geotechnical problems, including terrain settlement, sheet pile/diaphragm walls, slope stability, excavation analysis. It offers several material models for soils and a variety of structural elements such as walls, anchors, geotextiles or geogrids. The GEO5 FEM is used to compute displacements, internal forces in structural elements, stresses and strains and plastic zones in the soil and other quantities in every construction stage. With extension modules the program also performs the Tunnel excavation analysis, the steady sate or transient Water Flow analysis, the coupled Consolidation analysis, or the dynamic impact of an Earthquake.

This program is used for gabion wall design. It allows analysis of any structure shapes including overhangs requiring anchoring.

This program is used to perform slope stability analysis (embankments, earth cuts, anchored retaining structures, MSE walls, etc.). The slip surface is considered as circular (Bishop, Fellenius/Petterson, Janbu, Morgenstern-Price or Spencer methods) or polygonal (Sarma, Janbu, Morgenstern-Price or Spencer methods).

This program is used to determine vertical settlement and time-dependent consolidation of soils under embankments, foundations, earth dams and surface loads (surcharges).

The FEM - Tunnel is used to design and analyze tunnels. It include a specialized tools for the definition of tunnel lining, system of anchors and rock bolts and grouting-strengthen regions. The relaxation factor assigned to each construction stage takes the 3D effect of the excavation into account. Tunnel is an extension module of the FEM program for the analysis of general geotechnical problems.

This program is used to verify cantilever retaining wall design. It offers a number of wall shapes and analyzes reinforced concrete cross-sections.

This program is used for design of gravity retaining walls. It offers a range of wall shapes and verifies mass concrete cross-sections.

This program is used to verify retaining walls made of prefabricated blocks (retaining block walls)

This program is used for design and analysis of reinforced masonry block wall according to various standards.