FirePro UK Limited products

This is the standard control and indicator panel for a FirePro fire suppression system. With three co-incidence detection zones as standard, FirePro release is configured to activate from any combination of detection zone inputs to allow (among other combinations) any two from three type activations such as would be required for detection in ceiling void, room and floor void applications. To protect against unwanted automatic release of FirePro caused by extraneous smoke detector contamination and or dust, we advise the installation of one zone utilising smoke detection and the other detection using heat detection. This way, FirePro will only release on a confirmed fire, following the pre-determined release timer.

Sigma XT+ control panels are multi-area extinguishant control panels complying with EN12094-1, EN54-2 and EN54-4. Up to 8 zones of conventional detection with up to 4 extinguishant areas are available.

The Sigma XT+ ECU coincidence unit has two fully monitored inputs for connection to fire detection control equipment or addressable control modules to provide an EN12094-1 , EN54-2 and EN54-4 compliant extinguishant control system.

The FPC-5 is a cost effective solution for In-Cabinet systems where the use of a more sophisticated control system is not required. It is powered by a CR2 battery for up to 5 years operation. It has an integral heat detector or a linear heat detection cable can be used instead. All sizes of FirePro generators are designed to work with the FPC-5.

The FirePro BTA controller allows detection and automatic fire extinguishing in an enclosure with the use of a bulb thermal sensor at a pre-selected temperature. No electrical power source is required.

The FPX103 is a marine approved fire suppression control panel. It can be powered from the crafts 12 volt or 24 volt supply and can control and monitor up to 4 FirePro generators. It also has two monitored detection circuits that can be configured for coincidence operation. As it is only 83mm square it fits into the most crowded of control consoles.

The AMAC panel can activate up to a maximum of 84 FirePro condensed aerosol generators. The IMO certified panel is built in either light grey powder-coated or stainless steel housing. The AMAC panel can be operated from the front display or by the optional Remote Control Box.  There are alarm and fault contacts for connection to third party equipment.

The Sigma ZXT has an event log which records event data from the panel such as alarms, faults, configuration changes etc. along with a time and date stamp. This historical visibility is critical for diagnostics, identifying the cause of alarms and faults, as well as reasons for activations. Up to 1000 events can be stored within the panel which can be viewed through the LCD, or can be downloaded and saved using Kentec’s Loop Explorer 2 software. The system is compliant with EN54-2, EN54-4 & EN12094-1.