JDB Dense Flow, Inc. products

The Dense Flow Cone Valve, when combine with the Dense Flow Charging Hopper is able to achieve the same performance results where competitors require three or more valves on their Dense Phase conveying Systems. The Cone Valve is cast from ductile iron and features a machined sealing area that creates a stronger seal as the pressure within a conveying system increases.

The Dense Flow Densealloy Pipe Stub is a 2’ hardened section of SCH. 80 pipe. Our Densealloy Hardening process insures the stubs I.D. is 600 BHN which translates into a piece of pipe that will last up to 8 times longer than non-hardened pipe. The Densealloy Pipe Stub was designed as an alternative to replacing an entire length of pipe.

The Dense Flow Pocket Elbow is intended for use on pneumatic conveying pipelines, particularly where highly abrasive materials are being conveyed. The cast, short radius elbow body features a unique pocket at the materials deflection point. The deflection point is where material first makes contact with the elbow; it’s also the point at which wear is most likely to occur.

Dense Flow Cone Bottom Pressure Vessels are designed and built according to A.S.M.E. code with a pressure rating of 125psi, and temperature rating of 300 Deg. F. Standard pressure vessel sizes range from 1 cubic foot to 250 cubic feet in capacity.

The Dense Flow Capacitance Level Control is commonly used to detect high or low material levels in a bin, silo, etc. Every unit comes stand- ard with an enclosed control board that features probe sensiOvity adjustment, and fail safe high or low setngs. The control board is protected by a dust Oght aluminum housing, and is easily accessed through a threaded cap. The probe itself is
stainless steel, and probe funcOon can be tested while the unit is installed.