Mobiltex Data Ltd. software

LTE Swap facilitates the upgrade process from 2G or 3G cellular technology Mobiltex RMU2 and RMU3 units to corresponding pre-purchased LTE units. It helps transfer all settings and configuration data which allows for a quick and simple swap process. If needed, it will also update the firmware of the unit it is connecting to before completing the swap process to ensure that the most up to date software is being used.

corView is the web interface used to monitor cathodic protection systems that use Mobiltex`s corTalk® line of remote monitoring units. For systems that use RMU2 hardware, corView simply allows users to view measurements. However, for owners of other units, users can not only view all their measurements but also send commands back to the units. This app provides a new and intuitive way to access corView through your mobile device with a small screen optimized and simplified design.

This app is for configuring the corTalk® RMU1 (Remote Monitoring Unit 1) with a Bluetooth configuration interface. Both the RMU1PGM or RMU123PGM with RMU1ADP are compatible. They both function as a complete RMU1 programming interface but only requires the Bluetooth connection of your phone to use.

The RDL1 is used to monitor a wide variety of signals for all your cathodic protection needs. This app allows configuring the RDL1 and access to diagnostic information.

This app is for configuring the corTalk® RMU2 (Remote Monitoring Unit 2) with a Bluetooth configuration interface. Both the RBT1 or RMU123PGM are compatible. They both function as a complete RMU2 programming interface but only requires the Bluetooth connection of your phone to use.

This app is for configuring the corTalk® RMU3 (Remote Monitoring Unit 3) with a Bluetooth configuration interface. Both the RBT1 or RMU123PGM are compatible. They both function as a complete RMU3 programming interface but only requires the Bluetooth connection of your phone to use.

This app is for configuring the corTalk® uDL1 (micro Data Logger 1) with a uDLBT1 device. The uDL1 does not need to be plugged into a computer to set any of its settings, but still needs a computer to extract the data from the uDL1.

This app is for configuring the corTalk® uDL2 (micro Data Logger 2) with a uDLBT1 device. The uDL2 does not need to be plugged into a computer to set any of its settings, but still needs a computer to extract the data from the uDL2.

This app is for configuring the uGI1 (Micro GPS-enabled Interrupter 1). The uGI1 is used to monitor and control a cathodic protection rectifier by switching a relay at precisely scheduled intervals. This app allows access to basic information on the uGI1 and allows setting up 10 different profiles to meet the customer`s needs. Note that logs, due to their size, can only be extracted from the uGI1 using the PC configuration application through the USB port.