Poly Products, Inc. - A Senney Enterprises Company products

The Poly Products Corro-Fan is a premier in-line tube axial fan that is powder coated with a chemically robust two part Halar coating (ethylene chlorotrifluoroethylene). This coating provides corrosion resistance for a wide range of chemistries at temperatures ranging from 0 degrees F to 200 degrees F. The Corro-Fan has been used historically as simply the air mover of the Companion Condenser. However, it has recently found its place as a premier tube axial fan when corrosive air must be moved.found its own place as a premier in line Tube Axial Fan for any application where corrosive air needs to be moved.

These seamless ducts are leak-free and corrosion resistant. The design of our Corro-Duct in addition to the resistance polyethylene make this an ideal solution to even the most corrosive environments. Each Corro-Duct has a “slip fit” end so that it will easily slide into the adjacent mating Corro-Duct.

POLY PRODUCTS INC offers an optional AirScrubber (Mesh Pad)  to reduce the already minimal air emissions from the Poly Products EVAPORATIVE TANK™ by an additional 98%.  The AirScrubber (Mesh Pad)  consists of a 2” thick, knitted, polyethylene mesh pad with a spray wash-down system.  The spray wash uses about 4 gallons of water per cleaning.

Poly Products is proud to introduce the Poly Products Corro-Fan™.  Poly Products has used this fan most commonly as the air mover of the Companion Condenser™., but it has found its own place as a premier in line Tube Axial Fan for any application where corrosive air needs to be moved.

These systems are more compact. The smaller versions are ideal for small spaces, or for small runs. They have the same closed loop capacity ideally suited for dewatering spent solutions or wastewater that may have a high solids content. The MINI series is a more compact version and does not include platform and stand.

A filter press is used anywhere there is a need to separate heavy solids from a liquid. Most times the slurry will be pumped from the bottom of a clarifier cone or a sludge thickening tank into a filter press. The end result of the particulate accumulated from a filter press becomes a filter cake. Filter press with polypro plates for solids removal ranging from .5-100 cubic feet capacity.

The Poly Products Evaporative Tank is available in two models, the ET-II-W and the ET-III-W.  Each of these are ideally suited for dewatering spent solutions or wastewater that may have a high solids content. The evaporation mechanism eliminates any small, entrapping passages. Up AND down-draft spraying at very high flow rates produces high evaporation at moderate temperatures.

When installed with an EVAPORATIVE TANK™, the ET-Companion Condenser removes water from the evaporator`s air exhaust and returns it in the form of distilled water for reuse. The dry air is returned to the EVAPORATIVE TANK™ to work again.

The Poly Products Evaporator System evaporates water from process solutions and waste waters under atmospheric conditions. The highest evaporation rate can be achieved by heating the solution prior to pumping it into the evaporator. This is accomplished by using our heated tank with either a gas-fired burner, steam coil or electric heater. The patented (#4790904) ET Evaporative Tank ™ is molded out of polyethylene, with no weld seams, for leak-free operation. With over 2,000 products in the field, the Poly Products evaporator has proven to be the leader in atmospheric evaporation of water.

The cake from a filter press can be reduced by as much as 4:1 by utilizing a sludge dryer.