Shenzhen Fanhai Sanjiang Electronics Co., Ltd. products

The purpose of the SEC3002 Fire Alarm Control Panel (FACP) is to monitor input signals, give indications and possibly activate outputs as programmed. It is designed to comply with EN54-2 with qualities of simple installation, operation and easy maintenance.

The purpose of the SEC1000 Fire Alarm Control Panel (FACP) is to monitor input signals, give indications and possibly activate outputs as programmed. It is designed to comply with EN 54-2 with qualities of simple installation, operation and easy maintenance. The SEC1000 panel is an addressable fire detection panel with 1 loop of 120 addressable points and expansion capabilities. It is compatible with other peripherals made by Sanjiang with its own protocol.

A9030T point-type photoelectric smoke detector (Detector hereunder) is a kind of photoelectric smoke detector. With an internal microprocessor, it supports electronic coding and is accessed through a compatible fire alarm control panel via a two-wire bus. The detector realizes real-time acquisition of the in situ smoke concentration data and sends back the data to a fire alarm control panel. It can also receive and execute the control commands given by a fire alarm control panel.

The QM-ZSD-01E is the releasing interface which can be connected with Agent Releasing Control System or Starter, and is applied in conspicuous place of exit or entrance. When the Agent Releasing Control System is activated, the QM-ZSD-01E will show “DON’T ENTER WHILE RELEASING GAS” and alarm at the same time.

The C9065T Hold Off Unit provides a robust and convenient point to apply a temporary hold to release of fire protection extinguishant release.The robust pushbutton is shrouded to prevent accidental operation and is coloured to comply with the requirements of EN12094-1.

The RSU100 remote status unit is designed in according to European standard EN12094-1. The remote status unit is designed to extend the indication and partial control of the ECP1000 gas fire extinguishing control panel to locations outside of the extinguishant area, enabling the system to be used in a variety of application scenarios. Up to seven status units can be connected to each gas fire extinguishing control panel. All units connect to a two wire data communications bus and is powered by the auxiliary 24VDC output of the extinguishing control panel.

SJ-C-100w /G7000 emergency lighting controller (hereinafter referred to as G7000 controller) is a system platform integrating fire alarm control, emergency lighting plan and evacuation instruction plan. Its alarm information and escape information can be visually displayed and conveniently operated and controlled.It has good expansibility and can be applied to network distributed applications to realize real-time network monitoring.

When connecting the line, attention shall be paid to the positive and negative polarity of the power supply. When in use, it should be noted that the chassis shall be grounded well. In order to ensure stable operation of the system, the time interval of continuous switching shall be greater than 10 seconds. If the linkage control with external control panel is required, ensure that the operating frequency is not too fast.

The KT9213/MP3 preamplifier is a new generation of high reliability, high quality fire or accident emergency broadcasting equipment.It integrates with MP3 audio source. It can also cooperate with broadcast power player to realize background music broadcast function.