Model SIP 2000 - Operation and Programming Manual

The various input and output connections for the SIP 2000 are conveniently located on the bottom of the main control unit. For operation, insert the female end of power cord A into the male Plug A (shown in diagram above with a red “in” label) The opposite end of Plug A will fit a standard wall outlet but should not be plugged into a power supply until the SIP 2000 has been completely installed in the water dispenser. Insert power cord B into the female socket B (shown above with a green “out” label). Plug the main power supply cord for the water dispenser into the female or opposite end of cord B. The air pump is the small rectangular box found in the SIP 2000 box. The air pump power supply cord is permanently attached to the air pump and cannot be removed, this must be fitted to the SIP 2000 box in the area marked DC12v position in the diagram.