Browse all Channels
  2. Monitoring & Testing
  3. Laboratory Instruments

Laboratory Instruments

Articles & Whitepapers
  • A new solution for biosolids (sewage sludge)

    A new solution for biosolids (sewage sludge)

    It’s becoming increasingly difficult to dispose of biosolids (sewage sludge) in a safe and cost-effective way. The Dryclone® Air Drying System offers an efficient, safe, and low-cost solution that’s aligned with the future of biosolids usage. The Dryclone efficiently removes moisture content from biosolids, reducing t

  • CFR engine installation

    CFR engine installation

    The laboratory where the CFR engine is installed shall conform to the following conditions:It is desirable that the laboratory should be established in the ground floor and its floor should be bright ...

News

FDA Further Expands EUA for Thermo Fisher Scientific`s COVID-19 Diagnostic Tests

Anthias Consulting's Absolute Basics of HPLC & LC-MS Training Course Approved for CPD by the Royal Society of Chemistry

New Technical Note on Time Resolved Analysis with the Prodigy ICP Spectrometer

Teledyne Leeman Labs Introduces an all new Mercury Analyzer – the Hydra IIAA

Equipment & Solutions
  • inoLab Multi 9620 IDS/inoLab Multi 9630 IDS – Wireless Ready Multiparameter Benchtops
    Showcase

    inoLab Multi 9620 IDS/inoLab Multi 9630 IDS – Wireless Ready Multiparameter Benchtops

    Modern high-performance multi-parameter meters with two or three galvanically isolated measurement channels: pH/mV, ISE (including incremental methods), conductivity and oxygen measurement.  Up to three of the same or different parameters can be measured. With a large 16:9 color graphic display under a hygienic glass shield and antibacterial keyboard for use, even in critical areas. Use ...

Companies

Upcoming Events
  • 5-day Hands-on Complete GC & GC-MS
    Showcase

    5-day Hands-on Complete GC & GC-MS

    This course provides the theory of the GC and MS essential to any participant, along with the hands-on practical element in the laboratory to practice and re-enforce the theoretical knowledge. These courses are 50% theory and 50% practical in a lab environment. This course addresses gases and plumbing, sample introduction, analytical columns, GC detectors (FID and ECD), mass-spectrometry and data ...

1-day Hands-on GC Maintenance

Jun. 2rd - 2th | Milton Keynes

5-day Comprehensive Advanced GC & GC-MS Hardware Training (Agilent GC & SQMS)

Jun. 8rd - 12th | Milton Keynes

Validation, Verification and Transfer of Analytical Methods

Jun. 15rd - 16th | Amsterdam

1-day Absolute Basics of Karl Fischer (KF) & Thermal Analysis (DSC & TGA)

Jul. 8rd - 8th | Milton Keynes