- Home
- Companies
- BAMO Mesures SAS
- Products
- BAMOPHOX - Model 106 - pH-meter & ...
BAMOPHOX - Model 106 -pH-meter & ORP-Meter
The BAMOPHOX 106 offers high flexibility on use mixing different built-in programmes for regulation, thresholds, temperature compensation, and alarms. The 2 lines back lighted display, 16 alphanumerical characters, gives an easy measurement and temperature reading in any conditions. It also displays the configuration menu and settings of thresholds, analogical outputs, operation data modes, calibration steps. To allow a quick and easy diagnostic after configuration a simulation program is built-in with direct actuation on contacts outputs, analogical outputs and PID regulation. A copy of the signal on the 4-20 mA output is galvanic insulated; it can be set up within the all range of the parameter. Temperature measurement is also available on a 4-20 mA output (this output is not available when PID regulation is in use).
- pH/ORP programmable monitor and regulator
- Alphanumeric back lighted LCD display
- Friendly using menu
- Scales:
- 0 - 14 pH and ± 1000 mV
- through configuration
- Temperature compensation
- Automatic or manual
- 2 analogical outputs 0/4-20mA galvanic insulated
- 4 relay outputs (Normally Open contacts)
- 1 input to switch the regulation on Stand-by
- 2 models available:
- Panel mounting 72 x 144 (model 106E)
- Wall mounting IP 65 (model 106M)
- OPTIONS:
- RS 422 /J-BUS + LOGGER
- Extension for 2nd measurement input
- Allows a second measurement parameter (pH, Conductivity, Chlorine, Turbidity, Flow, and 4-20 mA, depending of the model)
- The data from this blind device are displayed on the main device (second line display).
- A 4 wires shielded cable is necessary to link both devices (maximum length of 500m)
- The options RS422 and the data logger are shared between both Bamophox.
- Displayed parameters:Measurement values pH/ORP - Configuration Menu - Temperature value
- Display:Back lighted - 2 lines of 16 alphanumerical characters ; 9,2 mm high
- Indication:LED alarms status
- Configuration:8 push buttons keyboard on front face - Keyword protected
- Scales:0 to 14 pH pH–meter configuration / ±1000 mV ORP–meter configuration
- Accuracy:± 0,03 pH or ± 3 mV
- Input impedance:>1013 Ω
- Probe input:coaxial connector, code 9054
Temperature compensation:
Automatic with an input for a 3 wires Pt 100 Ohm/0°C range, 0…100°C
Manually from 0…100°C
Relay outputs:4 closing contacts (Silver alloy), voltage free
Thresholds: 3 programmable independent thresholds - with adjustable hysteresis 0…100% - and adjustable timer from 0 to 9999 sec
Output relay (S4) Common alarm signal for:
- Too long injection
- Temperature out of range:
- pH>14 or open loop
- Pt 100 Ω dysfunction or probe cleaning function