FB - Model 6, 8 & 10 -Standard Rewindable Water Filled Submersible Motors
A series of rewindable submersible standard water lubricated motors with high performance, over sized and extraordinarily simple to maintain. Completely “MADE IN ITALY”, NEMA standard and made to meet environmental provisions. Thrust bearing, the real heart of the submersible motor, is of “Michell” bidirectional type with pads in treated steel and supported by a disk in resin compound fibres and self-lubricating additives, fully ecological. The union between these materials withstands impacts and exceptional axial thrusts for greater efficiency and safety.
The supports, upper and lower are in GS400 spheroid cast iron which give greater resistance to impacts and corrosion attacks by water.
The stator is covered by an AISI 304 stainless steel sheath that withstands stray currents.
The windings of asynchronous type are:
- for the “F” series in copper wire with insulation in PVC
- for the “F..C” series in copper wire with insulation in PE2 + PA, suggested for high temperatures, surges in tension and “Inverter Resistant”.
The rotor shaft is particularly strong, guided by pilot bush anti-wear bearings in graphite, completely in AISI 420 stainless steel without welding; it is ground along the entire axis thus giving the rotor concentricity such as to ensure perfect linearity. With balancing, a shaft free from vibration is obtained.
The mechanical seal, fitted in series, “SIC-SIC” silicon-silicon carbide and ensures optimum sealing even with sandy water.
The membrane ensures compensation for balancing the internal-external pressure of the motor.
The feed cable elastomeric reticulated mixture, of EPR type for foodstuff use, certified KTW, WRAS and ACS for drinking water.
The filler liquid clear water with addition of propylene glycol specifically studied to safeguard primary waters. It performs the function of cooling, antioxidant and antifreeze, ensures storage of the motor to -15°C.
Bolts and screws, simple things but not to be underrated, these are in AISI 304 stainless steel, well worked so as to avoid detachments from corrosion in the long term.
Y / Δ Start-up
Special feed tension
Different frequencies
PT100 temperature sensor
Flange for pump no rules NEMA
Flange: 6” - 8”: NEMA / 10”: see technical sheet
Insulation class: PVC: Y / PE2 + PA: B
Protection type: IP68
Ambient temperature: see technical sheet
Voltage tolerance: +6%/-10%
Installation under the water level: 350 m
Cooling rate: min. 0,15 m/s