Carver - Model 3710-ASTM -Hydraulic Compression Plastic/ASTM Presses for PE Sample Preparation

Carver ASTM presses are specially configured to perform the compression molding of test plaque or bar specimens of Type I, II, III, IV or V polyethylene and other thermoplastic resins. The procedure is in conformance with ASTM Method D 4703, Procedure C. The presses are equipped with heating/cooling platens and a programmable digital controller which has a heating/cooling loop for each platen and built-in program for the required 15°/minute +/-2°C cooling rate.

• Force Calibration Certificate using equipment traceable to NIST (part #1525.0001) [each]
• Floor stand 47"L-R x 22.5"F-B x 30"H Wt 280# (catalog #223219D)
• Floor stand 47"L-R x 22.5"F-B x 30"H W/6" Casters Wt 280# (catalog #223229C)
• 1/8 HP Vacuum pump (catalog #3874)
• Evacuable 6mm Pellet Die Set (catalog #4417)
• Evacuable 12mm Pellet Die Set (catalog #4946)
• Evacuable 13mm Pellet Die Set (catalog #3619)
• Evacuable 25mm Pellet Die Set (catalog #4369)
• Evacuable 31mm Pellet Die Set (catalog #3902)
• Evacuable 40mm Pellet Die Set (catalog #3876)
• Spare parts kit (part #6315.17)
  • Three pints of hydraulic oil, push buttons, rod seal, polyseal, relays & fuses
• Carver Special Hydraulic Fluid (Oil) (part #2170)
• Hydraulic Vent Valve (solenoid/cartridge valve & coil) (part #6315.19)
• UL/CUL Certified electrical panel available upon request as an option