Con-Serv Manufacturing
- Home
- Companies
- Con-Serv Manufacturing
- Products
- Con-serv - Line Pressure Reverse ...
Con-serv - Line Pressure Reverse Osmosis system
Con-serv Manufacturing announces its first Line Pressure Reverse Osmosis system with ERD* ( Energy Recovery Device). This revolutionary design uses the Hydro power of the Brine Water (discharge) to isolate the back pressure on the membrane that would otherwise reduce the efficiency. Only Con-serv provides multiple membranes with multiple ERD’s* on a single unit to deliver up to 450 GPD of Reverse Osmosis quality water. All with NO electricity required.
Most popular related searches
reverse osmosis system
reverse osmosis water purification system
reverse osmosis
carbon block filter
reverse osmosis water purification
4 stage reverse osmosis
reverse osmosis water
feed water
water purification system
booster pump
- No electricity required, powered only by hydraulic energy normally lost to drain
- Improves membrane life, prevents "TDS Creep" (high initial TDS from stale water sitting in the system or low-pressure conditions)
- Increases treated water pressure (up to 95% of feed pressure)
- Improves water quality by ensuring membrane efficiency
- When using a pressurized product tank, it decreases "Fill Time" by up to 65%
- Effective for inlet water pressure as low as 40 PSI
- Reduces drain wastewater by up to 80%
- (150 GDP - 1 membrane + 1 ERD*) (300 GDP - 2 membranes + 2 ERD`s) (450 GDP - 3 membranes + 3 RD`s)
*Energy Recovery Device
Model no: CS-PPRO 150/300/450
- Capacity: Produces 150 to 450 gallons per day of RO permeate depending on water temperature, pressure, chemistry variation)
System includes
- RO unit: 4-stage unit, all filters included.
- Installation& Service manual
System Requirements
- Working pressure: 40 to 80 psi feed water pressure required, if below 40 psi, a booster pump is needed. We have a RO system with booster pump assembly. If the input pressure is above 80 psi, you MUST add a pressure regulator.
- Working temperature: 90 ~ 40 deg. F ( 37 ~ 4 deg. C )
- pH range: 2-11
- If feed water has hardness level above 250 ppm membrane life could be reduced.
- If feed water has iron above 0.3 ppm membrane life could be reduced.
Filter Service Life
- 1st Stage Sediment filter : Recommend changing every 6 ~12 months.
- 2nd Stage Carbon block filter : Recommend changing every 6 ~12 months .
- 3rd Stage Carbon block filter : Recommend changing every 6 ~12 months .
- 4th Stage TFC/TFM membrane: Recommend changing every 2~3 years.
Warranty
- 1 years Limited Warranty on parts, components. Filters are not under warranty.