MaxxFlow - Model HTC -Fall through Measurement System

• Most non-metallic solids can be measured
• Can be installed on round pipes or ducts
• No real upper limit of mass flow
• Maximum pressure 10 bar
• Dust tightMost non-metallic solids can be measured
• Can be installed on round pipes or ducts
• No real upper limit of mass flow
• Maximum pressure 10 bar
• Dust tight
• No flow restrictions to the process flow (wear resistant ceramic liner)
• The mass flow measurement is independent of flow characteristics
• Maximum temperature, 12O °C
• Can be installed at an angle
• Small footprint, 220 mm (DN 100), 290 mm (DN 150), 310 mm (DN 200)
• No moving parts, hence no maintenance
• No flow restrictions to the process flow (wear resistant ceramic liner)
• The mass flow measurement is independent of flow characteristics
• Maximum temperature, 12O °C
• Can be installed at an angle
• Small footprint, 220 mm (DN 100), 290 mm (DN 150), 310 mm (DN 200)
• No moving parts, hence no maintenance

The MaxxFlow HTC is specially developed for the flow measurement of dry bulk solids during high-volume throughput. Due to its completely open profile and its low installation height, the MaxxFlow HTC is especially suitable in situation in which it was previously only possible to use complicated or expensive mechanical solutions, e. g. impact plates or measuring chutes.

The installation of the MaxxFlow HTC takes place independently of the direction of the line (vertical/inclined), but always after mechanical conveyor elements, e. g. rotary feeder, screw conveyors, air slides or chain conveyors.