BJM - Model SK Series -Solids-Handling, Non-Clog, Shredder Pump

FromIndustrial Flow Solutions (IFS)

SHARE

Solids-Handling, Non-Clog, Shredder Pump. Wear-resistant shredding and cutting system designed to tear, break, rip solids. Tungsten carbide-tipped impeller. Max solids from 1.6-3.5 inches. Motor housing: 304 stainless steel. High chrome suction plate. Dual mechanical seals. Seal Minder® moisture detection system. ANSI or NPT discharge flange. Integrated, removable pump stand. 33’ power and Seal Minder Cable. Heavy duty lifting rings. Built-in thermal protection. Class H motor insulation. 2-pole and 4-pole motors available. Single-phase and 3-phase voltages. 1HP – 20HP. Free-standing and guide-rail mounted compatibility.

Most popular related searches

solids handling pump

wear resistance

tungsten carbide

ALSO AVAILABLE IN 316 CAST STAINLESS STEEL (SKX-Series)

Longer Power Cord – Standard 33ft. power.
304SS Motor Housing – Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
Tough Pump Construction – Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.