2 products found

Industrial Test Systems, Inc. products

Copper

Johns Copper for Water Quality Testing (480042)

This water quality test promises to be an attractive alternative to wet chemical copper tests for several reasons: There are no hazardous chemicals to mix (an MSDS is not required); Quick results are obtained in less than 1 minute; No identified interferences; And, best of all, the Copper water quality test strips are safe and easy to use for fast accurate results within the ranges of 0 to 2 ppm (mg/L), which permits the measurement of typical copper levels found in well, tap, and stream water. The test is very convenient to run: dip test strip into sample for 30 seconds with constant back and forth motion, remove, and match color after 2 minutes to quantify the Copper level in the sample.

Copper (Cu+1 / Cu +2) for Water Quality Testing (480011)

Testing for Copper in water can be very time-consuming, not to mention costly and dangerous. Often, the operator is required to have a high level of skill in order to be able to manipulate the liquid-based testing kits normally used.

With WaterWorks™ and SenSafe™ Copper Check water quality test strips you can say goodbye to difficult tests. Simply dip one water quality test strip into your water sample for 30 seconds with a back and forth motion, remove the strip and shake once to remove any excess water, wait 2 minutes for the color to develop and match with the closest color match to determine your level of Copper.

Accurate water quality test results for home, lab, and on-site have never been this easy.