4 products found

Industrial Test Systems, Inc. products

Iron

Ida`s Iron Check (Fe+2) for Water Quality Testing (481046)

If low range detection of Fe+2 is what you need, this is the answer. Ida`s Iron Check is designed to specifically react with Iron, without interference from other heavy metals that may be present. Say goodbye to dangerous, time-consuming wet-chemical kits that require extensive training and cost. This patented test is a simple dip-and-read test procedure that requires no technical training. Additionally, since there is no glass required to run the test, and since the chemical concentration is extremely low, the test is ideal for use in controlled areas. Simply dip one strip into the water for 30 seconds with a back-and-forth motion, remove the strip and shake once to remove excess water, wait 15 seconds for the color to develop, and match with the closest color match to determine your concentration of Iron.

Ida`s Iron Check HR (Fe+2) for Water Quality Testing (480146)

If high range detection of Fe+2 is what you need, this is the answer. Ida`s Iron Check HR is designed to specifically react with Iron, without interference from other heavy metals that may be present. Say goodbye to dangerous, time-consuming wet-chemical kits that require extensive training and cost. This patented test is a simple dip-and-read test procedure that requires no technical training. Additionally, since there is no glass required to run the test, and since the chemical concentration is extremely low, the test is ideal for use in controlled areas. Simply dip one strip into the water for 30 seconds with a back-and-forth motion, remove the strip and shake once to remove excess water, wait 15 seconds for the color to develop, and match with the closest color match to determine your concentration of Iron.

Iron Check, (Fe+2/Fe+3) for Water Quality Testing (480025)

Patented technology allows for a detection sensitivity of 0.1 ppm (mg/L) on the Iron Check test strip. This test promises to be an attractive alternative to wet chemical iron tests for several reasons: There are no hazardous chemicals to mix (an MSDS is not required); Quick results are obtained in minutes; And, best of all, the Total Iron Test Strips are safe and easy to use for fast accurate results within the ranges of 0.1 to 5 ppm (mg/L), which permits the measurement of typical iron levels found in well, tap, and stream water. The test is very convenient to run: dip test strip into sample for 30 seconds with constant back and forth motion, remove, and match color after 2 minutes to quantify the Total Iron level in the sample.

Iron Check II, (Fe+2) for Water Quality Testing (481331)

If detection of Fe+2 is what you need, this is the answer. SenSafe Iron Check II for water quality testing is designed to specifically react with Iron, without interference from other heavy metals that may be present. Say goodbye to dangerous, time-consuming wet-chemical kits that require extensive training and cost.

This patented water quality test is a simple dip-and-read test procedure that requires no technical training. Additionally, since there is no glass required to run the test, it is ideal for use in controlled areas. Simply dip one strip into the water for 5 seconds with a back-and-forth motion, remove the strip and shake once to remove excess water, wait 2 minutes for the color to develop, and match with the closest color match to determine your concentration of Iron.