Pulse Instruments products

The Pulse Instruments AP-110 Series controllers offer a high level of flexibility in controlling water treatment applications. One sensor input is available that are compatible with a variety of sensors: Contacting conductivity with cell constant 0.01, 0.1, 1.0 or 10.0, Electrodeless conductivity, pH, ORP, Any Pulse Instrument disinfection sensor, Generic sensor (any type of sensor with a linear voltage output between -2VC and 2 VDC).

With high emphasis on maintaining wash water sanitation, it is critical to maintain and control sanitizer levels at all times during processing, to prevent the risk of cross contamination. Unlike on-line colorimetric monitors, the AP100-CD meter for active chlorine dioxide uses a membrane covered amperometric sensor that does not require the addition of special reagents. Model AP100-CD controller has a large display with icon based programming. It shows the current measurement value, push button set point selection, adjustable 4-20 mA output, and compact design. When the Chlorine Dioxide ppm value goes below the set point, a pump or valve is activated. When the measured value reaches the set point, it shuts the pump off. High and Low alarm points are set to alert the user in case the measured values exceed the upper or lower limits for normal operation.

The U-50 Series multi-parameter water quality meters are equipped to measure and log data for as many as 11 parameters simultaneously with one single probe. Experience the durability, reliability and intuitive software that will exceed your expectations. Monitor surface water and ground water by deploying the probe directly into a body of water or using a flow cell.