Gas Analyses Articles

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • LGD F200 - Designed for easy zeroing and span adjustments

    Regular zeroing and span adjustments to gas analyzers in the field are suggested and required for a variety of reasons. Compliance to environmental standards, e.g. those outlined in the US EPA (40 CFR) or EN 14181 is an important factor. Special application conditions, e.g. a varying gas matrix or compensating for pressure effects can be additional reasons, where a zeroing and span adjustment ...


    By Axetris Ag

  • Case study - Pure oxygen injection pilot test

    Introduction: The Moccasin Bend WWTP uses pure oxygen produced by a cryogenic oxygen plant for activated sludge treatment of the influent waste stream, which consists of municipal and industrial wastes. The waste stream contains a high proportion of high strength industrial waste, which results in a typical COD loading of about 2000 mg/L, which is approximately four times the strength ...

  • On-site Oil Analysis to extend oil drain intervals

    Fleets demonstrate ROI on do it yourself oil analysis “If the oil is good, why would you change it?” Gary Lentsch, CAFM, fleet manager for Eugene Water & Electric Board (EWEB), asked ...


    By Spectro Scientific

  • Heavy Duty 126 MW GT upgrade for aerodynamic performance improvement

    Scope of the Project Turbine Services Ltd. , a supplier of replacement parts for GE Large Frame Gas Turbines, has worked with SoftlnWay's engineering team on the redesign of the third stage of the GE Frame 9E heavy duty gas turbine. The scope of this project included the redesign of the third stage vanes and blades to create components competitive with the GE Advanced ...


    By SoftInWay Inc.

  • Case study - Geotech’s first GA5000 landfill gas analyser takes 100,000 readings for SUEZ environnement

    Geotech’s first GA5000 analyser, manufactured three years ago, was recently spotted in the company’s calibration rig.  This portable landfill gas monitor was the first production unit of the newly launched GA5000 gas analyser range and has prompted Geotech to look into the analyser’s life since then. The analyser was on its sixth service since manufacture, under ...


    By Geotech

  • A Nitrogen Culinary Experience and How to Remain Safe with Use of Oxygen Monitors

    As modernist cuisine has become more popular, restaurant and home chefs alike are turning to liquid nitrogen to create spheres, gels, foams, and even ice cream. While liquid nitrogen can be safely used in a range of culinary applications, there are important safety risks to be aware of when working with this substance.  The Hidden Dangers of Liquid Nitrogen in the ...

  • Digital Technology to Transform Oil, Gas Hiring Practices

    The oil and gas industry’s effort to adopt digital technology not only will impact its daily operations, but its hiring needs as well. The oil and gas industry must pursue digital technology for two reasons: an aging workforce and increased focus on safety, said Mike Weast, IT regional vice president with professional staffing firm Addison Group, in a statement to Rigzone. As the majority ...

  • Measuring oxygen levels in offshore extracted natural gas - Case Study

    Teekay use the EC92DIS portable oxygen analyser on board the Voyageur to measure the oxygen levels in the gas. In March 2013, one of Teekay's largest projects, the Voyageur Spirit FPSO achieved the first oil extraction on the Huntington field in the United Kingdom. The production unit was installed for its new charter contract with E.ON Ruhrgas UK E&P (E.ON) and is expected to last for ...


    By Systech Instruments Ltd

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Sea Level Rise: Risk and Resilience in Coastal Cities

    Introduction One of the most dire impacts of anthropogenic climate change is a rise in the global sea level caused by the melting of glaciers and land-based ice caps, as well as a smaller increase from expansion due to the higher temperature of the water itself.  Unlike some other predicted effects of climate change, this impact has already been observed for some time.  Indeed, ...


    By Climate Institute

  • Serviceability assessment and sensitivity analysis of cast iron water pipes under time-dependent deterioration using stochastic approaches

    Determination of the depth of the corrosion pit is essential to predict the serviceability of corrosion affected pipes and to instigate maintenance and repairs for the pipeline system. In this paper, a reliability-based methodology for serviceability assessment of corrosion affected pipes is presented. The depth of corrosion pit is considered as the critical parameter that causes ...


    By IWA Publishing

  • Optimising laboratory environment for successful IVF outcomes with Geotech’s G100

    The accuracy of incubator gases within an IVF laboratory plays a major role in success of IVF programs in any fertility clinic today. Given the crucial role that the incubator plays in the IVF process, the conditions within the incubator in an IVF laboratory must be optimal at all times to increase the likelihood of a successful assisted reproductive treatment. Geotech’s ...


    By Geotech

  • The Path to Safety for Pharmaceutical and Laboratories: Why O2 Deficiency Monitors May be Required?

    To safeguard against gas leaks in pharmaceutical industries and laboratories, businesses are turning to oxygen deficiency monitors. Learn when, where, and why an oxygen monitor or O2 monitor may be required.  Oxygen Monitors in Medical and Pharmaceutical Settings In the hospital setting, nitrogen gas is ...

  • Optimization of a microwave-assisted extraction procedure for the determination of selected alkyl, aryl, and halogenated phenols in sewage sludge and biosolids

    A microwave-assisted extraction method for the determination of 15 alkyl, aryl, and halogenated phenols in sewage sludge and biosolids samples was developed and optimized. The effects of solvent, temperature, time, moisture content, acid, and number of extractions on the recovery of phenols were evaluated. Results indicated that extraction solvent had the greatest impact on the recovery of all ...


    By IWA Publishing

  • Design and Analysis of a High Pressure Ratio Mixed Flow Compressor Stage

    I. Introduction Smaller frontal area and high thrust to weight ratios of mixed flow compressor stage has resulted in its application for small gas turbine engines in aviation sector [1] . The efficiency and reliability of the compressor depends to a great extent on flow behavior in its flow passage and its interaction between impeller and diffuser. The complex turning of the flow not only ...


    By SoftInWay Inc.

  • Why high temperature combustion of landfill gas?

    Due to the accumulation of knowledge and the tightening of environmental law, the landfill technology has increasingly become concerned with the management of trace compounds in landfill gas. With landfill gas, contamination is through sulphur, chlorine, fluorine, halogenated hydrocarbons and heavy metals. Other trace elements such as volatile organic compounds (VOC), impose environmental ...


    By Hofstetter BV

  • Comprehensive analysis of tobacco smoke using TD–GC×GC–TOF MS with Tandem Ionisation

    The hazardous constituents of cigarette smoke have attracted considerable attention lately, especially with increasing regulation around the world limiting or banning smoking in public places – and even in private cars if children are present. From an analytical perspective, however, there is much that remains to be learnt about the composition of cigarette smoke, because of its high degree ...


    By SepSolve Analytical

  • PureAire Oxygen Analyzers & Oxygen Monitors for Nitrogen Generators

    Nitrogen has many uses in industrial applications where oxidation would be undesirable. From carbonizing beer to preserving food, reducing fire danger, and cleaning equipment, nitrogen is a safe, inexpensive gas. For companies that need a steady supply of nitrogen gas, nitrogen generators work well. Learn about the uses of nitrogen generators and why you should use oxygen monitors in ...

  • FTIR gas analyzers support management of fire at UK waste facility

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents.  Arrangements have been made in England to bring together experts from the Environment ...


    By Gasmet Technologies Oy

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you