Only show results in Connecticut? Ok

Waste & Recycling Applications

  • Premium

    Hand-Held & process control water testing instrument for Circuit board cleanliness testing industry

    Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-28809 has been used as a guideline for control. Now a simple 'on line' test for the relative measurement of ionic contamination has been developed. This fast and economical method for testing circuit board cleanliness uses a Myron L ...

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Premium

    Temperature and gas sensing solutions products for industrial electronics

    Optimize performance, boost functionality, and decrease costs. Industrial electronics require high power quality thanks to equipment and process control sensitivity (e.g., factory automation equipment, semiconductor processing, etc.). As a power system designer, you're faced with changing safety regulations, greater performance and functionality demands, increased costs, and size reduction ...

    By Advanced Energy based in Milpitas, CALIFORNIA (USA).

  • Premium

    Elemental Analysis for Semiconductors & Magnetic Media by EDXRF / XRF

    Semiconductor device fabrication is the process used to create the integrated circuits (silicon chips) that are present in everyday electrical and electronic devices. It is a multiple-step sequence of photographic and chemical processing steps during which electronic circuits are gradually created on a wafer made of pure semiconducting material. Silicon is the most commonly used semiconductor material today, along with various compound semiconductors. The entire manufacturing process, from start to packaged chips ...

    By Applied Rigaku Technologies, Inc. based in Austin, TEXAS (USA).

  • Premium

    Advanced water purification technologies for semiconductor and electronics sector

    High-technology industries use ultrapure water in their manufacturing. SnowPure’s components help sell pure water systems to semiconductor, electronics, solar panel, hard disk drive, glass lens, and flat panel display industries. These industries often require “ppt” (part-per-trillion) level impurities. EDI and UV-TOC are key technologies in these ...

    By SnowPure Water Technologies based in San Clemente, CALIFORNIA (USA).

  • Premium

    Recycling equipment for shredding electronic scrap (E-scrap)

    Processing electronic scrap (E-Scrap or WEEE) presents special challenges. Computers, consumer electronics, and IT equipment need to be destroyed to extract recyclables or ensure the security and complete destruction of the product. Hard drives, tapes and data storage devices must be completely destroyed to provide data security. And, while many electronic scrap items do not require the specific size reduction that hard drives or other data storage devices require, all electronic scrap includes recoverable ...

    By Granutech-Saturn Systems based in Grand Prairie, TEXAS (USA).

  • Premium

    HSE protection & sustainability management software for electronics industry

    Producers from the electronics industry are facing massive challenges in regards to global competition with other manufacturers. Extreme time pressure and dwindling delivery periods whilst being able to maintain consistent quality at the same time means that optimum planning of resources is essential. For the same reason, companies rely upon an efficient system for their occupational safety and environmental protection and, in order to permanently stay on top of permits and obligations, recurring technical ...

    By Quentic GmbH based in Berlin, GERMANY.

  • Premium

    Analytical spectrometric instruments for RoHS and WEEE

    A lot of European, US and international directives has been introduced for reducing the impact of harmful elements in consumer goods on human health and environmental. The best technique for screening of products for heavy metals and restricted substances is X-ray fluorescence analysis due to its excellent sensitivity (lead, mercury, chromium, antimony and other hazardous elements can be detected at ppm level), high performance and non-destructive ...

    By Elvatech Ltd based in Kiev, UKRAINE.

  • Premium

    Metals separation equipment for cleaning metal pollutants from WEEE

    REGULATOR-CETRISA, as manufacturer of metals separation equipment, offers different solutions for cleaning metal pollutants from. Before the E-Waste enter into the shredding process, any contaminating material, like batteries, color cartridges, tonners, etc., must be removed manually from the incoming ...

    By Regulator-Cetrisa based in Gava, SPAIN.

  • Premium

    Industrial air pollution control for the electronics and electrical industry

    The world's appetite for electronic devices - from simple household appliances to sophisticated computers - has led to rapid growth of both these industries. Typically for the electronics industry, there are large waste gas streams (up to 400,000 Nm³/h) with relatively low concentrations of different solvents. The waste gases mainly occur in coating, cleaning and etching processes during the production of semiconductors, CDs/DVDs, Blue-ray discs, DVTs, TFT-LCD and plasma displays. The electronics industry has ...

  • Premium

    Innovative gas measurement solutions for electronics industry

    Incredible advances in micro-miniaturization of electronic components, integrated circuits and microprocessors have benefited our world and will continue to produce new solutions and conveniences. These advances have resulted in extraordinary innovations, such as very powerful, compact computers, cell phones and various telecommunications devices. And these devices, though inconceivable just a few decades ago, are now common place ...

    By Advanced Micro Instruments, Inc. (AMI) based in Costa Mesa, CALIFORNIA (USA).

  • Oxygen Generating Systems for Waste Gas Treatment in the Semiconductor, PV and LED Industries

    Waste gas treatment is an often overlooked but important function of Semiconductor, PV and LED fabrication. Several serious accidents have taken place in factories where no abatement was installed. Even today waste treatment is often seen as a cost rather than a safety issue. There are three main reasons why waste gas treatment is installed in factories: health and safety, environmental factors, and quality ...

    By Oxygen Generating Systems Intl. (OGSI) based in North Tonawanda, NEW YORK (USA).

  • Waste Sorting - CRT Glass Sorting

    End of life TV sets and computer monitors require to be recycled to maximise the level of material recovery, and to meet the requirements of the EU WEEE Directive. CRT glass is the largest item by weight. However, because of the 2 different types of glass used in CRT manufacture, the glass fractions have to be sorted to achieve a separation of the 2 type of glass, i.e. panel glass sorted from funnel glass. X-TRACT separator is able to sort the panel glass from the funnel glass. It does it by comparing their ...

    By TOMRA Sorting GmbH based in Asker, NORWAY.

  • Water quality monitoring for semiconductor industry

    Water is fundamental to the manufacturing process in a semiconductor facility. Electronic components are rinsed or washed several times during the producing process with ultrapure water (UPW) to remove residue. Continuous monitoring of organic constituents (TOC) on the influent city water assist with UPW production. Good quality waste streams for the manufacturing process can also be monitored for reuse ...

    By Real Tech Inc. based in Whitby, ONTARIO (CANADA).

  • Fiberglass Reinforced Plastic (FRP) Equipment for Semiconductor or Microelectronics Industries

    Semiconductor or microelectronics industries have specific high requirement for their production processes, including storage, handling and processing of mediums such as hydrochloric acid, hydrofluoric acid, phosphoric acid, sulfuric, nitric and so ...

    By Zhongyi GRP Industrial based in Jizhou, CHINA.

  • Air purification solutions for data centers store and protect sector

    Data centers store and protect such valuable digital information as bank accounts, streaming movies, websites, libraries, healthcare data, and government statistics. All of those computer electronics are vulnerable to corrosion caused by air ...

    By ProMark Associates, Inc. based in Skokie, ILLINOIS (USA).

  • Shredders for Electric and Electronic Equipment (WEEE) and Refrigerators

    Electric and electronic waste (WEEE), are coming from technology products such as home appliances (washing machines, vacuum cleaners), computers and tools. An economy based on the consumption such as today, provides a continuous increase of WEEE, and determines an increasing risk of dropping out in the environment or in landfills, with the consequences of pollution of soil, air, water and health human repercussions. These products should be handled properly and used for the differential recovery of the materials ...

    By SA Eng. based in San Donà di Piave, ITALY.

  • Recycling sorting solutions for the electronic scrap sorting - weee

    The growing demand for high-value, secondary raw materials makes targeted recycling increasingly attractive. In the EU alone, experts estimated over 8 million tons of disused electrical equipment in 2010. TOMRA Sorting’s goal is to utilize electronic scrap sorting to sort out pollutants as well as high-purity ...

    By TOMRA Sorting GmbH based in Asker, NORWAY.

  • Industrial shredders for WEEE/cables industry

    Since 2003 in Europe, the professionals of the sector of the electric and electronic components must organize dies of recovery, recycling or valorization of their called worn products WEEE (Waste Electrical and Electronic Equipment). Before the evolution of the legislation, Préciméca proposes since 1998 a machine (range 01-02) for the treatment of electronic cards. Large electric household appliances (ranges 50-02, 14-02, 17-02) with the Small household products (14-02, 12-02) to the data-processing components, ...

    By Precimeca based in Toulouse, FRANCE.

  • Reliable Shredding Technology for Electronic Scrap

    Our customized solutions enable you to efficiently shred electronic scrap in your recycling facility and they align perfectly with your recycling system. The granulate size is adjusted such that metals and non-metals can be separated and recycled as best as possible. More than 40 million tons of electrical and electronic scrap are generated annually – and the trend is growing dramatically! Recycling electronic devices is not just beneficial for environmental reasons. This scrap, as a rule, contains many ...

    By UNTHA Shredding Technology Gmbh based in Kuchl, AUSTRIA.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you